Rated 4.8 out of 5 by 12
Rated 5.0 out of 5.0 by bob made my air conditioner quite
put these under my air conditioner that was make a lot of noise and made a Hugh improvement. My pad was connected to the house which caused vibrations, this help to reduce this as well
September 8, 2015
Rated 5.0 out of 5.0 by LATechster Adequate Product
We needed the pads to dampen any vibrations on a laboratory table that will hold 700 pounds. I think they are adequate rubber and will do the job. Easy to order on-line and pick up at the local store a few days later.
August 25, 2015
Rated 5.0 out of 5.0 by mongo great purchase
Great value, Price was competitive. easy to instsll
August 5, 2015
Rated 5.0 out of 5.0 by Teejayache Great Product
This product is a sturdy rubber product that reduced the vibration and noise that my compressor was making on the concrete floor. I have the compressor in a bathroom in my shop, and I mounted it onto these, put a weather seal around the door frame, and the noise level was reduced probably to 75% of what it was before. I'm hoping in the long run, these make the compressor last longer because the vibration is now caught in these instead of vibrating the entire compressor itself.
April 7, 2015
Rated 5.0 out of 5.0 by NOVAArchitect It's a block of rubber, so not much could go wrong.
it works as discribed. though it is kind of expensive for a piece of rubber. then again if it was a block of rubber for a boat, or a wedding, then it would be triple the price, so overall an average value.
July 8, 2014
Rated 4.0 out of 5.0 by Suslee Seems to be working
I bought these to place under my washer. My porch floor has a slant that shims could not fix. My washer still vibrates some, but it no longer walks across the floor.
January 20, 2015
Rated 3.0 out of 5.0 by rayfromrhodeisland pricey chunk of rubber
These are a bit pricey for what they are. They are just 4x4x 0.5 chunks of rubber with a 1/2" hole in the center. The compressor legs deform the rubber. A metal plate is needed to spread the compressor weight over the entire block. I used 4x4 blank square electrical box covers with the knockout in the center (SKU # 201960) to put between these rubber blocks and the compressor legs, and also used extra covers as shims to level the compressor.
January 13, 2015
Rated 5.0 out of 5.0 by mjr0531 Exactly What I Ordered
Vibration isolators have greatly reduced the noise when the AC unit on the roof cycles on. Just slip the isolators under the unit and done.
Product arrived quick even with standard shipping it only took a couple of days.
July 23, 2011