Rated 4.5 out of 5 by 21
Rated 2.0 out of 5.0 by ERISANation Beware using as replacement
I bought one to replacement the original one in the door. Diameter going in was the same, however, there is no lip on the top and it fell into the hollow core door.
July 14, 2016
Rated 5.0 out of 5.0 by Catino work out great for me!
it was a perfect replacement of my old ones. no complaints. easy to install and good quality parts.
June 24, 2016
Rated 3.0 out of 5.0 by Jim Forced to order online
The housing for the ball bearing is cheap pot metal and that failed on the item I have now replaced with this new one.
The Brunswick store showed 12 in stock but the store personnel could not find any. By ordering on line, it did cost twice as much as it should have.
February 11, 2016
Rated 5.0 out of 5.0 by WSBK Small but quailty item
I used a pair of these drive-in ball catches as replacements for the 7 year old ones that failed (different brand). I lifted the old ones out and since the retaining sleeves remained in the holes, I slid the black sleeves off the ball catches and dropped them in. The catch plates were already in place so no need to mount them. I didn't have to adjust the ball heights. It took only a few minutes to do both doors (pantry doors) and they work better than the originals.
June 2, 2015
Rated 5.0 out of 5.0 by Miki Easy to install
Easy to install, replaced worn out parts with these, took about five minutes.
June 23, 2015
Rated 4.0 out of 5.0 by Ricky Works well but.....
I received this drive-in ball catch quickly from Home Depot. It has a good brass finish on the strike plate and the ball moves smoothly in it's casing. The only downside to the purchase was it does not have a brass plated mount plate for the ball latch so I had to shim the ball latch up to engage the strike plate.
June 9, 2015
Rated 5.0 out of 5.0 by Got2go Perfect Fit!
This ball catch was an exact match for the ones that needed to be replaced in my French doors. Installation took less than five minutes. Perfect!!
April 21, 2015
Rated 5.0 out of 5.0 by codefool Needs better specs
This was to replace a door catch, and from the specs I "guessed" that it would fit the existing hole from the old one. The specs were confusing, and I wasn't sure, but I ordered anyway thinking I could always return it. Although it did fit perfectly, I think it would be helpful if the specs included bore hole size, or what size augur would be used to drill the hole, etc, so that I could at least take some measurements and be sure about it. Since it wasn't carried in the store, I couldn't take the old one in to compare. Make this easier.
September 24, 2013