Rated 4.2 out of 5 by 18
Rated 5.0 out of 5.0 by dogwalker Good replacement option for circa 1980 drawer track
I searched for a replacement back plate for our 1980 cabinet drawer track. The original back plate was plastic and had cracked. It must be different than modern sizes as I never could find just the back plate. I was prepared to replace the whole drawer track, but fortunately didn't need to, the metal back plate from this kit worked with the old track. This kit would have worked fine if I had needed to replace the whole shebang. The quality seems as good or better than the original drawer track. See the photo of the old plastic back plate, in case you have the same style back plate.
September 13, 2016
Rated 3.0 out of 5.0 by Homeowner Nice for the price
Was easy to use, but a little difficult to install.
September 13, 2016
Rated 3.0 out of 5.0 by Danny Took some thinking...
This installation took a little more Time than originally planned.
Reason being that the Cabinet Opening where the Rollers were to be mounted needed to be raised a good Inch (1") so that the Rollers would work correctly and not Bottom Out. So I needed to add a piece of lumber to remedy this.
But besides that extra work...
I am Satisfied with the end result.
I Would/Will use these again.
March 2, 2016
Rated 3.0 out of 5.0 by Mario Good for the price
I was able to install it without major problems, however the metal of the rollers mounting brackets is thin and not very strong, until now since about three weeks has been working good.
January 5, 2016
Rated 5.0 out of 5.0 by gup replacements
easy to install and as close to the original as possible
October 20, 2015
Rated 4.0 out of 5.0 by Plinkers Nice kit
Full set nothing needed but tools ................
September 1, 2015
Rated 4.0 out of 5.0 by TC Drawer Slide
The kit contained sufficient parts for the kitchen drawer, and after a modest amount of work, I made the drawer slide work like new.
July 28, 2015
Rated 3.0 out of 5.0 by Gookie Metal Track Kit Review
No real instructions on how to position your drawer for mounting. Hint- Make sure drawer is pushed all the way in and square, then position your end track and mark your drill holes for the screws. The two rollers on both ends are a joke. Had to bend them up to try and gain some support for the drawer. They are not strong enough. I should have just left the existing plastic tabs on both ends, at least they did not squeal every time the drawer is opened. Good Luck.
April 7, 2015