Rated 4.5 out of 5 by 11
Rated 5.0 out of 5.0 by Rick Better than 1-1/2 ton aluminum jack from Harbor Freight
Purchased this floor jack to replace a 1-1/2 ton aluminum jack from Harbor Freight because the aluminum jack outer frame got bent due to a lateral load. Both jacks had the same lifting range of 3-3/4 inch to 15 inch. I was expecting 14 inch but when it arrived, the box stated 15 inch. When I measured the maximum lift, it was indeed 15 inch so I suspect the company redesigned the jack and Home Depot didn't update their webpage. Using my bathroom scale, this steel jack's weight was only 2-3/4 pounds more than the aluminum jack (29.4 lbs vs. 26.8 lbs) but the steel jack lifting capacity is 4,000 lbs versus 3,000 lbs plus the steel frame is an angled plate which will resist a lateral load. The 1-1/2 ton aluminum jack frame from harbor freight are only two flat aluminum plates which can easily bend. A lateral load can happen if you jack the car up on the front end and since the car is at an angle, there is a tendency to roll backwards if you don't block the rear wheels. In this situation, a lateral load is placed on the jack and unfortunately for me, I bent the aluminum jack. One drawback to this steel jack: You must remove the handle to operate the valve while the 1-1/2 ton aluminum jack you only need to turn the handle. Here is a photo of my bent aluminum jack and this 2 ton jack side by side.
November 19, 2015
Rated 5.0 out of 5.0 by Frixos Great jack
This is the first jack I've owned. I bought it so I could work on my Mini Cooper - thus the low profile. It works great. Easy to jack up the car. The maximum height is higher than I expected from a low profile jack. I have only used it when I changed the brake fluid on the car, but I'm happy with the purchase!
April 5, 2016
Rated 5.0 out of 5.0 by Sly Good, well constructed floor jack. Great pricing.
Well constructed. Excellent price. Lower profile was perfect for the low height of my sports car.
April 5, 2016
Rated 5.0 out of 5.0 by ChrisJ So far so good
I just bought the jack and have only used to remove summer wheels/tires and install winter.
But it seem very sturdy and easy to use.
January 6, 2016
Rated 5.0 out of 5.0 by 315 Excellent Product
This jack works great on low profile cars. Easy online checkout and very fast shipping. A+++
January 12, 2016
Rated 4.0 out of 5.0 by none000 Pro Lift 2T floor jack 767
This jack was listed as #7 on the top 10 floor jacks and at the best price I found for the unit. It arrived ahead of time and worked as described. Compact, lightweight. and easily stored. I do not know about durability of service as I have only had it for about a week but appears to be well made although the saddle is smaller than expected. And if the lifting arm were a couple of inches longer, it would be better in my opinion, but is acceptable for the maintenance I need to do.
September 1, 2015
Rated 5.0 out of 5.0 by Gopai works for my BMW335i so far so good
Used 4-5 times in 9 months since bought and so far so good. Low profile size is suitable for my bmw335i ground clearance. If successfully raised your car, the maximum height is able to reach 14" high, which is enough for your oil change, coolant change, transmission oil change, etc. You can ask more for such a price. One thing is very important is you need to turn oil pump knob right to the dead end when lifting your jack, otherwise, it will be leaking half way and can not go far. I am satisfied with this purchase anyway and hope it will last for 2 years.
August 23, 2014
Rated 4.0 out of 5.0 by MechaHeretic Good for the Price
So far I've only used it about 5 times, but it gets the job done. The jack itself is a little short length-wise, and "low profile" part kinda goes out the window midway down the body, making it difficult to use on lower stock cars. I wouldn't advise this for any tuners out there with dropped suspension. I drive a stock '02 mini cooper and the black handle section as gotten caught under the side trim once or twice.
The saddle is smaller than I had anticipated and, depending on your jacking points, might need some load-bearing mod to reduce the chance of puncturing or deforming the undercarriage. I've had to use a short section of 2x4 in between the saddle and vehicle to prevent the "teeth" of the jack from puncturing my lift points. Also, where the pump handle slides into the jack has a very small "locking" tab, so it slides out often trying to pump up the vehicle.
Overall, so far, a good purchase. You do have to pump it a bit, but i wasn't expecting a speedy lift for the price. Mechanically it has performed perfectly so far, but some of the paint has already rubbed off the handle near the receiver on the jack itself.
March 18, 2014