Rated 4.0 out of 5 by 9
Rated 5.0 out of 5.0 by Larry Worked on 3 cm granite
I'm always sceptical about anything that says it can handle granite, but this worked just fine. Had a 1" hole I needed to increase to 1 3/8". Filled the hole with putty, hot glued a jig of 3/8" thick plastic to the countertop with a guide hole that I filled with water. Only needed to make this one hole so the price made that reasonable. This gamble paid off.
May 3, 2014
Rated 3.0 out of 5.0 by Taffydog Drilled hole in ceramic like butter
Drilled hole in ceramic like butter . The bad bit not round . Wobbled in chuck and the cut was 1 1/2 times the width of cutting surface was sold as 1 3/8 drill actual more like almost 1 1/2 inch . if you had to drill deep you would run in to problems from Wobble .
May 1, 2014
Rated 1.0 out of 5.0 by Jeff Did not work as advertised
The description states that the tool will cut holes in porcelain tile. After attempting to drill a hole and breaking several tiles, I looked at the fine print on the tool's packaging and it stated that a porcelain drill bit may be required to start the center guide hole.
February 11, 2014
Rated 5.0 out of 5.0 by Jersan Got the job done
The drill in the middle is a plus. Finished the job another had started.
May 8, 2014
Rated 5.0 out of 5.0 by drill tile drill workef great
I used this in a drill press with a water spray bottle. The drill worked perfect
March 11, 2014
Rated 5.0 out of 5.0 by chris6101 Good
Take the drill out use only diamond edge. Start at angle 60 deg. or so, once you have cut in slowly straighten your drill till you at 90 deg. Look up youtube has some good vid.
December 31, 2013
Rated 4.0 out of 5.0 by kielykj Good quality for the price
Great product for the price! Cut 2 holes with easy and still has life left in it. I was cutting on a flat surface so I didn't need the water tank for vertical surface but could come in handy.
September 24, 2013
Rated 3.0 out of 5.0 by Lance11111 Poor water delivery led to rapid degradation
Water delivery is useless unless drilling horizontally. Even then, pilot bit doesn't get water (only the outer hole saw does). Pilot bit wore out rapidly, and only by drilling pilot with another bit could I get the hole saw to cut.
April 16, 2013