Rated 3.5 out of 5Â by 8
Rated 5 out of 5Â by pmah Great For Dressing Wet Saw Blades
I bought this QEP rubbing stone with the intention of using it to clean up the edges of tiles and noticed that it said you could cut into it with a dull wet saw blade and it would expose a new layer of diamond. I did this and it really worked. I cut about 20 feet of porcelain tile dressing the blade every few feet, and it cut like new after each time. It pays for itself the first time you avoid buying a new blade. Like others have said this stone is not worth a chit for taking ruff edges off tile. An angle grinder with a masonry wheel and a light touch works very well for that.
April 21, 2014
Rated 4 out of 5Â by RickyTools Only one a stone for both material (stone & glass) for finished
Only one a stone for both material (stone & glass) for finished
May 27, 2014
Rated 1 out of 5Â by EWALD1916 QEP Rubbing Stone
Stone actually broke during use. It is too soft to smooth the edges and ends of floor tile. When you pass it over an edge it will groove the stone but not dress the edge. The material the stone is made out of simply is not hard enough and the glue holding the grit together is too weak.
June 7, 2010
Rated 1 out of 5Â by boardhog Product wore out quickly
I have used other similar stones when installing tile to rub down the edges. This one wore through before I was finished with the job which was rather small, only about 20 pieces of tile. I would not purchase this again.
March 25, 2014
Rated 3 out of 5Â by pmike A good tile installation accessory.
The rubbing stone does what it's suppose to do. It does require "elbow grease", but it does take the edge off cut tiles for a better finish product.
January 19, 2012