Rated 5.0 out of 5 by 16
Rated 5.0 out of 5.0 by topgun3 Best cutting blade for marble
This blade surprise me how good it cut the marble sink,no chatter, chip out or distortion from the blade.Was quite concerned how this would cut to fit the sink top to the base. Very pleased. Thanks.
June 1, 2016
Rated 5.0 out of 5.0 by RG great product. did just what i had hoped it would do.
excellent blade. cut right through the 5 mil granite like butter!
May 31, 2016
Rated 5.0 out of 5.0 by Lou Diamond saw blade
I used the saw blade in my circular saw. It cut blue stone easily and cleanly.
June 7, 2016
Rated 5.0 out of 5.0 by Scott Great blade for Cambria
Needed to make some modifications to my Cambria quartz countertop. After reading some reviews of this blade, I took a chance. Happy to report that this blade on my circular saw--combined with a light stream of hose water--cut through the quartz with ease!
May 31, 2016
Rated 5.0 out of 5.0 by texmln Works well dry cutting granite
I used this blade in my circular saw to dry cut the ends off of a 3/4 inch thick granite vanity top. It worked great and wasn't much different than ripping a piece of plywood, save for the dust. The cut was very clean, better than I expected given that the granite was low end.
April 30, 2016
Rated 5.0 out of 5.0 by Monster Cuts Like Butter
I was looking for a blade that cut granite with the diamond knock out for my worm drive saw
I could not believe Home Depot did not stock this blade
It came in two days and did the job
Definitely use water when cutting as this will prolong blade life
April 5, 2016
Rated 5.0 out of 5.0 by ngran Excellent Blade
Worth every penny. Im new to all this so i started with a simple remodeling project, my half bath. I decided to use 12"x12" marble tile for the floor. I didn't buy a fancy wet table saw so the blade that came with it was janky and cheap. I took forever to cut through the tile. I cut 2 tiles and decided I need a better blade. Did some research and found this one. Cuts great and saves you a lot of time.
February 26, 2016
Rated 5.0 out of 5.0 by Ken Superb!
Just got done dry cutting an "in place" 1-1/2" thick granite counter top for a kitchen sink. The new sink was bigger that the old one so I needed to enlarge the opening all the way around. Effectively I cut a new opening. Watched a few videos (mostly wet saw) but figured Rigid knew what they were advertising when it said "Wet / Dry" on the packaging. Put it in my worm drive skill saw and BAM! Of course I took all the right safety precautions - ansi rated eye protection, ear plugs, dust mask. Used a shop vac to keep the dust mostly under control. Just take your time. Think safety. So easy I now wonder why I was so hesitant. Well worth the 45.00 price tag.
September 7, 2015