Rated 3.9 out of 5 by 8
Rated 4.0 out of 5.0 by TheFreezy2005 Gets the Job Done
This blade looks and feels much like the blade I took off to replace. I don't notice that the edge is any more "sharp" than the old blade. But then again, I have not gone through a ton of these either. This blade cuts well as my current project involves porcelain tile. I have to cut VERY slowly in order to get a straight cut. That could just be the nature of the material. The saw itself has lasted and doesn't seem to chip the porcelain too much on the back edge. It has lasted plenty of cuts so far as I picked up this blade halfway through a 4x5' shower tile in.
May 13, 2015
Rated 5.0 out of 5.0 by RidgidMan The best one I found so far
That blade came with the Ridgid R4040 saw. I tried 4 differents other brand, much more expensive blades. None of them gave me the same cut quality and they didn't last as long as this one.
April 16, 2015
Rated 5.0 out of 5.0 by Fritz Great tile blade
Best blade I have used. No chipping. Nice clean cuts
March 25, 2015
Rated 5.0 out of 5.0 by Kris 8inch ridgi tile are the best
it works really good is strong and makes really good cuts i recomend to every body to use it
February 25, 2015
Rated 5.0 out of 5.0 by AndyF great wet saw blade
I used the blade to install a marble back splash in our kitchen. The saw made fine as well as wide cuts.
Performed well on miter cuts and still cuts like new. A bit pricey, $50, but is holding up well.
January 23, 2015
Rated 1.0 out of 5.0 by Jacksonville Bad blade
Blade was bent when we installed on saw. Made saw have a bad vibration.
January 9, 2015
Rated 5.0 out of 5.0 by davey awesome blade
this blade is one of the best that I've ever used. i'm full time flooring installer and tile specialist.
I've used many blades in my carrear and this is one of the best. holds up good on long cuts and wears very well. I would recommend this blade.
February 27, 2014
Rated 1.0 out of 5.0 by bobg junk
It's garbage. I could not make a cut cause the blade kept bending. Ended up putting the old blade back on the wet saw and eating the 50 bucks.
January 27, 2014