Rated 4.3 out of 5 by 6
Rated 1.0 out of 5.0 by Johnnycat Cord grip design stinks
The cord grip design on this connector belongs on a cheap 15 amp extention cord.
September 22, 2015
Rated 5.0 out of 5.0 by PAULB Twist lock plug model L1430P
This plug is very sturdy. It is fairly easy to assemble even if one has only limited experience with these types of units. The only problem I encountered with assembly was with the built-in cable clamp. I was using no. 10 four wire lead cable for my feed into my transfer switch. This cable is approximately 3/4 of an inch in diameter, including insulation. The built-in cable clamp on this unit was too small to properly fasten my size cable to the plug without potentially cutting the insulated sheathing as the screws for the clamp get tightened. However, with a little bit of filing and grinding, the inside semi-circles of the cable clamp were easily increased to incorporate my no. 10 electrical cable and hold it securely to the plug.
September 30, 2014
Rated 5.0 out of 5.0 by Kwaz Good quality connector
It would have been nice to have had it in stock, on the shelf, during the hurricane instead of my needing to order it and receive it 2 weeks after. My fault for procrastinating and not getting a generator setup weeks in advance.
October 4, 2011
Rated 5.0 out of 5.0 by GerryU High quality product
Very rugged design and easy to install. I use it with my 7000 Watt emergency generator and it works great. Only negative is that it took a few days to get it since it must be ordered.
October 22, 2011
Rated 5.0 out of 5.0 by TomB Has all the desired features
The part was just what was needed to complete the the set up for the wiring of a standby generator.
February 13, 2012
Rated 5.0 out of 5.0 by laplataco commercial grade
Made a professional looking cable using 10 gauge wire.
December 19, 2011