Rated 4.6 out of 5 by 10
Rated 5.0 out of 5.0 by john146 It just works
I needed this to add the border in the boiler/laundry/water heater room. It just worked.
October 10, 2016
Rated 5.0 out of 5.0 by Buddhaloco Come to Poppa
Used this stuff for the first time. I was impressed, impressed with how well it adhered. Hint cut all your pieces to size first, this stuff set ups fairly quickly in the applicator, which I was a bit dissatisfied with. It oozed out the side seam.
September 22, 2016
Rated 4.0 out of 5.0 by BambooTho Kitchen project complete!
The last step to our recent kitchen rehab was to put up the baseboard molding and an end panel for the island cabinet. This adhesive caulk was used on both. When I re-did the bathroom I used standard adhesive caulk for the baseboards before I found this stuff. The difference that I could see is that this is a lighter composition, comes out kind of like a foam and is not as inclined to drip out of the tube when you are not looking. It dried faster and filled gaps well. I still used nails to tack things in place, but only a few. I had hoped to not have to use nails on the cabinet end panel, but just like the longer baseboard, it needed something to secure it in place while the adhesive dried. Bottom line is that this is good for light weight adhesive projects.
July 4, 2015
Rated 5.0 out of 5.0 by John Good adhesive, works as intended
Worked as intended and went further than I expected. Good initial tack helps with installation. Goes on off-white, but dries tan. Cleans up with water.
May 10, 2016
Rated 2.0 out of 5.0 by goodreason Better Adhesives Out There
Prepared the vinyl molding and walls per instructions. Next day applied the adhesive to the wall using the spreader and applicator and proceeded to install the molding. The adhesive did work in spots, but the overall adhesion was pretty poor. The following day I went back over the spots that came loose and in doing so, some more of the molding came off. Used a stronger adhesive that bonded the molding to the wall almost instantly.
June 17, 2015
Rated 5.0 out of 5.0 by Bob Great Product
I recently build a raised garden using concrete blocks and wanted something that would hold the bricks together without much fuss or work. This stuff works great and you do not need to use a lot of it. Will see how long it holds up as it has only been a couple weeks. So far, well worth it.
April 29, 2015
Rated 5.0 out of 5.0 by NotsoDIY The right product for the job
I am not handy. This adhesive held the cove base to the wall on the first try, with no fight. If all things went this well, I'd have far less fear doing projects myself.
December 23, 2014
Rated 5.0 out of 5.0 by modnik Strong Adhesive Bond for Vinyl Tile
I had several self-sticking tiles that didn't stick on their edges because the concrete floor wasn't perfectly flat. I tried putting reqular vinyl tile adhesive down that dried first but still the tiles came up. I removed the tile completely from the floor and put a bead of this Robert 7200 adhesive along the edges and rolled the tiles down with a wallpaper roller. They now stuck tight. I only wish I had started the job with this stuff. Washes off with water and comes off of the face of the vinyl tile for easy clean-up.
April 22, 2013