Rated 4 out of 5Â by 67
Rated 3 out of 5Â by Thatlldo Does the job - nothing more
I needed a sliding shelf/draw to go into an awkward spot and I thought of using sliders and making the shelf myself but these looked like they could save me a lot of work.
They do, but the materials used are just enough to get the function done and no more.
The base is thin woodboard like material. The sides and front back are pine and just functional. The sliders though are very basic. What you might get in a Target dressing table draw set.
For $69 I was hoping for better sliders and materials so somewhat disappointed and if I were to do it again I would buy good sliders and make the shelve using different materials.
However the job got done and the shelf and sliders have large tolerances which means that even with my bad woodworking skills the shelves work. Just not sure for how long.
If you are using this product in a finished environment, be prepared to sand, stain/paint for a while.
January 3, 2014
Rated 5 out of 5Â by Bill Very pleased with this product.
I bought and installed two of these roll out shelves for my daughter. She is so happy with them she now wants a few more of them in her kitchen.
The instructions were a bit lacking in detail but common sense always works as this stuff is not rocket science.They took longer to instal than I had planned. The spacers provided were not long enough which involved a trip to the hardware store for the correct length, plus longer screws. All in all it was a good experience.
March 4, 2014
Rated 4 out of 5Â by Thomas 22 IN. DEEP DO-IT-YOURSELF PULLOUT SHELF
The shelf itself is a good value (good wood, etc.) but depending on the installation may require a more work for fitting, sizing and anchoring. If you are installing as a free-hanging (no pantry shelf for support), the extra, plastic braces included are of no value--you will need solid wood pieces.
One small (sore) point: the shelf platform or floor-piece should be an extra ~1/2 inch larger (forward-back) in order to cover the entire wood frame. I used extra-wide top screws to secure this piece to the wood base. The directions assume you will only use the left and right side brackets. If you will be putting a lot of weight (like large cans and bottles) then you will want to secure the base properly.
August 26, 2014
Rated 3 out of 5Â by magic An Adequate Product
Cutting and assembling was straightforward. There should be a "weight limit" specified with the product. After installing the shelves, at 29" wide, and with a sizable but not excessive load on them, just a slight wobble when pushing them closed, caused the shelves to fall off the tracks at the back.
There needs to be a lip on the lower track to capture the nylon wheel more aggressively. I had to install an intermediate brace through the lower track to stabilize it.
Additionally, my initial order came with all right hand mounting brackets. A lot of phone and e-mail time and two weeks' wait for the correct brackets for the left side.
September 23, 2014
Rated 5 out of 5Â by Terry very well built shelf
supplied with two left-hand rear mounting brackets but didn't use them in the install anyway. width measurement is critical for slides.
August 26, 2014