0032886849435

Romex

Model 28828226

Internet #202210508

Store SKU #908500

15 ft. 12/2 Soild SIMpull NM-B Wire

$9.17 /each

Frequently Bought Together

Product Overview

The Southwire Romex SIMpull 15 ft. 12/2 NM-B Wire features a SlikQuik-infused membrane (SIM) Jacket that helps to minimize pulling force for easy installation. For use in dry interior applications.

Specifications

Dimensions

Details

Warranty / Certifications

More Products With These Features

Search

Customer Questions & Answers

26 Questions42 Answers

Customer Questions & Answers

15 ft. 12/2 Soild SIMpull NM-B Wire
15 ft. 12/2 Soild SIMpull NM-B Wire

Ask your questions. Share your answers.

 
 
Clear Search Term
 
 
Sort By:
This question is from 1000 ft. 12/2 Solid SIMpull NM-B Wire
 
1 answer

Can I run this wire 75ft for two florists lights with 20amp

This question is from 1000 ft. 12/2 Solid SIMpull NM-B Wire
Asked by
Read all my Q&A
June 8, 2016
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answer (1)

June 15, 2016
Answer: 
No. 1 conductors per phase utilizing a #10 Copper conductor will limit the voltage drop to 2.63% or less when supplying 20.0 amps for 75 feet on a 120 volt system. **Note to User:All ampacity values are taken from the Section of 310-15 of the NEC. The conductor characteristics are taken from Table 9 of the NEC. The calculations used to determine the recommended conductor sizes for branch circuits are Read More
No. 1 conductors per phase utilizing a #10 Copper conductor will limit the voltage drop to 2.63% or less when supplying 20.0 amps for 75 feet on a 120 volt system. **Note to User:All ampacity values are taken from the Section of 310-15 of the NEC. The conductor characteristics are taken from Table 9 of the NEC. The calculations used to determine the recommended conductor sizes for branch circuits are based on 60°C ampacity ratings for circuits rated 100 amps or less or marked for use with #14 AWG - #1 AWG. Circuits rated over 100 amps or marked for conductors larger than #1 AWG are determined using 75°C ampacity ratings. Calculations to determine service and feeder conductor sizes are based on overcurrent device ratings rather than actual expected loads which are conservative and may yield oversized conductors. No calculations take into account temperature correction factors or conductor de-rating.
This voltage drop calculator is applicable only to NEC applications. It does not optimize conductor sizes for several different loads at various points in a circuit. The total combined load and length of the circuit must be used. Consult with an engineer if your application requires more complex engineering calculations.
Read Less
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
This question is from 1000 ft. 12/2 Solid SIMpull NM-B Wire
 
2 answers

How much does a 1,000 ft roll weigh?

This question is from 1000 ft. 12/2 Solid SIMpull NM-B Wire
Asked by
goessel kansas
Read all my Q&A
May 29, 2016
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (2)

May 31, 2016
Answer: 
approximately 82 lbs.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

May 30, 2016
Answer: 
The weight is 81.8 lbs.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
This question is from 250 ft.12/2 Soild NM-B Wire
 
1 answer

Will 2 of 12/2 fit in 3/4 emt

This question is from 250 ft.12/2 Soild NM-B Wire
Asked by
Read all my Q&A
April 26, 2016
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answer (1)

April 27, 2016
Answer: 
No, it will not fit properly. The maximum allowable percentage of conduit fill is 40.0%. By using 1 1/4" you will comply with code. The above advice is based upon the current edition of the National Electric Code (NEC). Free access to the latest version of the NEC is available online at www.nfpa.org/freeaccess. The NEC and local building codes regulate the types of wire and cable that can be used in Read More
No, it will not fit properly. The maximum allowable percentage of conduit fill is 40.0%. By using 1 1/4" you will comply with code. The above advice is based upon the current edition of the National Electric Code (NEC). Free access to the latest version of the NEC is available online at www.nfpa.org/freeaccess. The NEC and local building codes regulate the types of wire and cable that can be used in specific electrical applications, as well as the manner of installation. Check your local building codes before you start any wiring and cable electrical project and be sure to obtain required permits. When your work is complete, always have it inspected for compliance with local codes to ensure that it has been safely installed. Read Less
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
 
1 answer

what is the weight of this 2 roll pack?

This question is from 250 ft. 12/2 (2-Pack) Yellow CU SIMpull NM-B Wire
Asked by
North Richland Hills, TX
Read all my Q&A
April 8, 2016
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answer (1)

May 16, 2016
Answer: 
aproximately 40 lbs.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
2 3 »
  • 2016-09-08 T13:06:43.201-05:00
  • bvseo_lps, prod_bvqa, vn_prr_5.6
  • cp-1, bvpage1
  • co_hasquestionsanswers
  • loc_en_US, sid_202210508, prod, sort_default
2 3 »
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 37ms
  • QUESTIONS, PRODUCT

Customer Reviews

Rated 4.2 out of 5 by 23 reviewers.
Rated 3.0 out of 5.0 by good wire short roll high price Good quality wire, but the roll I bought was 171 inches long, while 15 feet is 180 inches. Doesn't make much difference to me, but it is annoying. The 250 foot roll is a much better deal, but who knows if it is actually 250 feet. November 19, 2015
Rated 5.0 out of 5.0 by It's wire what more do you want! This is typical romex wire 1000' spool makes it easy to install. June 7, 2016
Rated 1.0 out of 5.0 by Simpull can't measure a foot 25'roll came with less than 20'. Maybe buy a tapemeasure from someone dudes April 8, 2016
Rated 4.0 out of 5.0 by Romex The product is fine but you need to pack them better. UPS package's must withstand a 3ft drop and believe me they need too. When we got the wire the reels were all broke we can use them but it makes it hard to roll off the wire April 12, 2016
Rated 5.0 out of 5.0 by best deal best deal / price, just what I ordered and good product March 22, 2016
Rated 5.0 out of 5.0 by Good to work with Pulls great with no curls like you get with 250 foot rolls, this saves a lot for time. The 1000 foot rolls may be a little more but my time is worth more than the price difference. March 11, 2016
Rated 1.0 out of 5.0 by Poor value Why buy one when you can buy two for more than twice the price? This sounds like it's supposed to be a deal, but it's not. Currently the double pack costs more than twice two individual 250 ft packs. So why would you buy it? (This could change, but it appears the 2-pack is less changeable to market forces, so conservatively costs more than two individual packs.) Don't. Just order two 250 ft packs and it'll be a lot cheaper. February 9, 2016
Rated 5.0 out of 5.0 by Easy maneuvering, simpull I picked up this cable from local HD @Rosenberg #6530. It is very easy to use. The price is great and product is excellent, and it is made in the USA. July 27, 2014
  • 2016-09-08 T14:21:29.458-05:00
  • bvseo_lps, prod_bvrr, vn_prr_5.6
  • cp-1, bvpage1
  • co_hasreviews, tv_23, tr_23
  • loc_en_US, sid_202210508, prod, sort_default
2 >>
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 34ms
  • REVIEWS, PRODUCT