Rated 3.9 out of 5 by 187
Rated 5.0 out of 5.0 by Fistimepainter very good product
For your project to be successfull, you must be ready to do a good washing ,degreasing and etching of your garage floor. After that, follow instructions about temperatures and you will be fine. I was able to complete this project with no previous painting experience. Now my garage look very good.
July 18, 2016
Rated 5.0 out of 5.0 by MJB 100% Satisfied
I was hesitant in buying this product based on the various reviews. I spent 1 day cleaning the garage floor. I first swept and then vacuumed the cracks of all debris. Next I used Krud Kutter (product from Home Depot) and a hard bristle scrub brush to clean the entire garage floor. Once thoroughly scrubbed, I used our pressure washer to rinse. Day 2 I rinsed the garage floor with the garden hose to Etch. Once this process was thoroughly done, I squeegeed the floor and put 3 fans on to dry the floor. That evening, I did a few minor concrete patches. I continued to use the fans to dry the garage floor. Day 3 I rolled the Epoxy Shield and added the decorative paint chips. I again used 3 fans to dry the floor. After reading numerous articles, I found that adding a topcoat is best in preventing paint peel or hot tire pick up. I purchased the Rock-Solid Clear Topcoat from Home Depot. The Top Coat cost more than the Epoxy Shield Garage Floor Coating Kit ($149). It also states that the Top Coat will cover 200 - 250 sq. feet. My garage is 500 sq. feet. I found that I was able to use only 1 pouch to cover my entire garage floor. I waited 4 days for drying time. I have driven both cars on and off the garage floor after running errands into town and there is absolutely no paint peeling or hot tire pick up. All in all I invested $301.41. The key is to do a thorough scrub down of your garage floor and adding the topcoat. I highly recommend both products (2 GAL. 2-PART HIGH-GLOSS EPOXY GARAGE FLOOR COATING KIT AND ROCK-SOLID CLEAR TOPCOAT).
July 4, 2016
Rated 5.0 out of 5.0 by Jarod great product
This product was awesome. Some reviews left me a little worried about peeling of the floor but I can say that mine has not done that. To have good results you have to put a lot of time into the prep work. Scrub it more than recommended and make sure it's completely dry before applying epoxy. Don't walk on it during the drying time. If you follow the directions then you'll have a great floor that everyone compliments. I have now had mine 2.5 years and have not had a single issue and I believe it's because of the prep work I did. Overall it's a pretty simple DIY job and gives a great look. I am moving into a new house soon and will be reapplying.
August 20, 2016
Rated 2.0 out of 5.0 by JNTX Need to redo the garage.
I followed the instructions to the T. I even waited a day and had fans running to dry the garage. But after a few months mine has started to peel and come off. I need to do it again but I don't want to waste the money unless I know why it peeled off. I know it works. I've helped friends to paint their garages.
June 2, 2016
Rated 5.0 out of 5.0 by Erreertt For those who can't etch or new concrete
Results will vary and if you can do the etch you really should.
But with new concrete and if water does not bead up you will be OK
This is a interior work room addition so I could not etch because I couldn't use a lot of water or hose due to my new drywall.
Drywall had just been mud and sanded so lots of junk on the floor. That's OK just clean it well. I used a trowel and just scrapped the blobs off the floor.
I swept well and mopped twice with a cheap 10$ mop and a water bucket. Dust was took care of and only slight traces where the blobs were.
Temp was 68° . I Let dry 4 hours after mopping.
And waited the proper induction time after mixing with this temp.
My concrete is not smooth flat, my beagle ran across my slab I noticed a couple hours later so we had to spray it down and try to level with a 2x4. You will see this in the photos. This is why it looks like it has lines in it . the epoxy covered it very well for the base slab condition.
May 13, 2016
Rated 1.0 out of 5.0 by homeowner If you want painting your garage floor to be an annual ritual, use this product
I have a very big garage and spent a lot buying multiple gallons of this product. Spent nearly a full day on my hands and knees doing surface prep, following the instructions. Mixed the epoxy, applied it, and it looked wonderful. You could eat off this floor! Then winter came (Chicago area). Cars parked with their usual snow and salt melting off onto the floor. In the spring, the good news is that because of the high gloss finish, the dirt washed off easily. The bad news is that the finish washed off as well. So I touched up, this time using the non-mix epoxy by Rustoleum. THis did not match. Left a flat finish. Does not wash easily. And also fails - I have bare cement in patches, yet again. I haven't found the right product, but I can tell you for sure that it is not Rustoleum.
August 23, 2016
Rated 5.0 out of 5.0 by JD Great
Great product! It was very easy to use and very easy to apply. I have a 2 car garage and it was more than enough of paint and color chips.
Preparation is the key, the actual application is just like painting a wall.
- Make sure you have an even surface, this is just like paint so you will see through the imperfections.
- Don't be afraid of using a good amount of paint (don't be scared you will run out of paint). I was being a bit conservative and had some leftovers but my floor could have used a bit of a thicker layer of pain for the imperfections, still looks amazing.
March 8, 2016
Rated 5.0 out of 5.0 by Kumar Easy to install
This is very and simple to paint.
I will update review after 1 year to see how it looks like.
Now these are not in boxes. Instead coming in the bags (pouches). If you see any video, you will see containers.
One thing I have observed is need to clean/wash floor 1 day before only.
April 25, 2016