Rated 3.8 out of 5 by 13
Rated 4.0 out of 5.0 by Matt Works well
This product did what I needed almost as well as Plastidip. Coverage was great and the color is white, not off white or anything like that. Adhesion is excellent but not hard to remove. The product is not easy to clean either. Scrub too hard or spray too high of PSI and you could damage it. I would recommend this product as an alternative to Plastidip if necessary.
August 4, 2015
Rated 1.0 out of 5.0 by Sobe747 DO NOT USE
This product claims its safe for plastic but it isnt! I used this on my brand new mustang's interior and it completely ate the plastics leaving cracks and weird looking marks...the 6 dollar can ended up costing me 550 I'm damages...and Rustoleum is yet to respond...STICK TO PLASTI DIP! It actually works!
August 20, 2015
Rated 5.0 out of 5.0 by 2gtsvette Multi-use spray paint!
This paint is great, It goes on like normal spray paint, yet gives the paint surface a nice texture and feel. If you are bored of it there is no need to sand and prep your surface again. You can just peel away the paint!!
July 3, 2014
Rated 2.0 out of 5.0 by mophead Very thin!
I will recommend this product with some caveats. First and foremost, it goes on very thinly. I suppose it has to be thin to be used in a spray can. As several reviewers have stated, several coats are necessary. I used this to coat a metal pole in my garage to keep car doors from being nicked. At first, I thought that I had bought a clear FlexiDip. Several coats later, there is enough coverage to provide a rubbery surface, and the original surface is now covered. I do like the surface that this provides.
March 15, 2015
Rated 3.0 out of 5.0 by Doc766 Great decorative coating with a soft touch
The FlexiDip white spray paint in 11 oz. aerosol can works well when used on a solid white, gray or tan surface. It does not cover prints or bright colors well--even with multiple coats--but performs well on the lighter colors. The lid for the aerosol can was very easily removed and replaced by squeezing the sides. The finish, when dried thoroughly, is soft to the touch and lightly durable. I tried the FlexiDip on an ivory light-switch cover plate made of hard plastic but had problems with the finish scratching off with use. I found the dried coating difficult to remove completely. Care must be taken when applying the coating to vertically oriented surfaces as the uncured coating tends to run and drip. I was able to use the product on a small section of white brick which had become stained over the years and was pleased with the look and feel of the finish after two coats and overnight drying. I think this product will find many different uses in a normal home setting.
February 20, 2014
Rated 5.0 out of 5.0 by JimmyDIY Worked Great
Worked as advertised and turned my sons rims bright white. He is very pleased with the product.
March 7, 2015
Rated 1.0 out of 5.0 by NickT Not plasti-dip
Bought this as a replacement for plasti-dip on a project that I started. Once I started spraying this on, the existing plast-dip started melting off leaving a very bad mess. On other parts that were bare, this stuff is very thin and does not coat well. It's the same price as plasti-dip as well.
December 18, 2014
Rated 4.0 out of 5.0 by Randy Spray Paint
easy to use and satisfied by objective. Cost effective and Home Depot personnel was very helpful
October 7, 2014