Rated 2.6 out of 5 by 5
Rated 1.0 out of 5.0 by rmoco Poor Results for Traffic Striping
We used the Yellow color of this paint on a factory floor with moderate Lift Truck and foot traffic. Lines appear excellent at first but almost completely disappear WITHIN HOURS because even the fully-dried (36+ hr cure) paint is an absolute dust magnet that is difficult to clean. These floors see paper dust only, not oil, grease or other chemicals; just dry dust, and the dust on the lines cannot be swept away. We have years-old, beat up oil-based-paint lines that look much, much better. The loss for us is not primarily in the paint itself, but in the manhours of application labor! If you use this product, your lines will become and stay dirty! - Manufacturing Engineer
September 16, 2015
Rated 4.0 out of 5.0 by chris A little hint
Use a clearcoatspray after your yopaint has dried. It will keep the lines looking greagreatgreagreatandlast a long time.
April 27, 2016
Rated 2.0 out of 5.0 by Fred Too light, shows marks
This is a much lighter blue than the usual blue. Worse yet, it shows dark from tires and even shoe prints in a week. Will return to the store.
August 9, 2015
Rated 1.0 out of 5.0 by Handipainter Wrong Color Blue!
If it's the wrong color, it doesn't matter how good of paint it is. Lots of solids at the bottom of the can, so it took a while to hand mix it. I realized right away that I should have had it mixed at the store, (Home Depot). Coverage was good, but the color was way too light. It's just not the dark blue that matches the handicap signage that I must also install. Why would Rust-Oleum call it Handicap Blue? I could be sued for not being handicap compliant!
February 17, 2014
Rated 5.0 out of 5.0 by JimS Excellent Color and Texture
Covered really well. Excellent application via brush. Tip: have HD mix it up before leaving store. Seems liked it had excessive liquid and had to use a paper towel to blot up some of liquid to be able to pre-mix. Store mixing would overcome that. Otherwise the paint is really a winner.
October 29, 2013