Rated 4.3 out of 5 by 25
Rated 3.0 out of 5.0 by Leo Ok but nothing worth the money...
Product is fine but not worth the price. Ryobi accessories are proving to be hard to find and not available at the store. That usually doesn't translate well for me.
June 24, 2016
Rated 4.0 out of 5.0 by Dave Bought online - could not find in store
I got what I wanted. And that's actually a BIG deal! I needed a way to route the straight edges of my cabinets - to widen the doorways just a bit. This has allowed me to do just that. There was only 1 little problem. The guide rails was too deep for my shelves so I had to shorten their depth by about 3/16"... with a hack saw, but it worked and now the job is so much easier than I was contemplating!!! I could not buy this guide in the Home Depot store, only online at HomeDepot.com. It was worth the wait (about 1 week).
April 20, 2016
Rated 5.0 out of 5.0 by Pluto Good product
The guide fit the router with no probles. It works as advertised.
May 3, 2016
Rated 5.0 out of 5.0 by george As advertised
They should not sell the plunge router without this guide. The bars are a little sticky, but a bit of sand paper and you are off and running. I have no real complaints other than not buying it sooner.
April 19, 2016
Rated 5.0 out of 5.0 by hammer Fit's just like he said
I had to ask if this would fit as my router is a different model. The question was answered very quickly and as he said it fit's. Can't ask for better service.
April 13, 2016
Rated 1.0 out of 5.0 by WildBill Ryobi Router Rip-Off
While clearly labeled as fitting the Ryobi router I already own, this router edge guide not only did not properly fit the router, once finally attached to the router the edge guide was impossible to remove. Poor alignment.
In order to remove the guide from the router, I had to cut it off with an angle grinder.
Poor fit, poor overall quality.
I do not recommend this product.
March 15, 2016
Rated 5.0 out of 5.0 by Astro Well made
Easily mounts and fits well, no slop. Makes my routing much easier. The screws could be a slightly coarser thread though. It seemed to take forever to screw them fully in, but now they will never leave the router base so all is good
March 15, 2016
Rated 5.0 out of 5.0 by KF5QEO Ryobi Edge Guide Review
If you don't have a Router Table, your going to need an Edge Guide. Many companies make them, no sense in paying more for one than you need. The only Caveat which is true for any edge guide is that you need wood to grip to on both sides of the blade to be able to use it. You also need to be using this close to the edge of the wood. With that in mind, you can put a second block of wood to allow you to get closer to the edge, though if you need a straight line in the middle of the wood, you'll need to setup a block of wood with a clamp. I use it for making an inner frame on the inside of my signs, and making mortissen joints with the straight bit. There's surely many more uses, but this is what I have the most uses for. I can setup the edge guide on one board to where it puts the edge of the blade at the end of the depth of one 2x4, then notch several 2x4's without having to measure. Each one will be notched to the proper depth and length! Saves a lot of time.
March 27, 2014