Rated 3.5 out of 5 by 4
Rated 3.0 out of 5.0 by cubereporter a little sticky
This is the only product of its type that I could find to hold my EZ-Pass to my car windshield. The glue on the fasteners spread over the edges and got on my fingers. I only needed small pieces, but had to buy the pack with more than I needed. That's not 3M's fault.
August 23, 2016
Rated 5.0 out of 5.0 by Anton Great product, leaps and bounds over Velcro
First off, this product is not what I would consider a "value" product -- it is expensive for what it is, but in this case you very much get what you pay for. These strips have been life savers for those odd jobs where tape won't do it, glue can't cut it and you need a solid seal that you can depend on. I highly recommend these for hanging up electronics (my router attached to the side of a book case comes to mind) or any other application where you might have to remove the item you're attaching every once in a blue moon.
I did also want to respond to the review on here from "Idahoabc" -- who did not read the instructions and rated the product poorly. Had he followed the posting instructions, he would have realized that this is rated to hold 1 pound for every 2 inches of fastener used and he used too little of the product.
Overall, highly recommended -- I always keep these on hand now.
April 7, 2016
Rated 5.0 out of 5.0 by Rob2049 Perfect for EZ Pass
Exactly what you need to secure your EZ Pass to your windshield (this is the same fastener various states send with your toll pass, FYI).
May 4, 2014
Rated 1.0 out of 5.0 by Idahoabc Does Not Live Up to the Advertising
Used to hang a large poster board, approximately 5 lbs. Four 1x3 strips used (each corner), failed within one month destroying the poster board. Painted sheet rock wall, smooth corrugated plastic board, 1/4 inch thick. 1/2 peeled off the wall, 1/2 peeled off the board . Will not use again.
February 26, 2015