Rated 4.4 out of 5 by 73
Rated 1.0 out of 5.0 by Jack Does the plastic taste ever go away? It's been well over a year!
Very easy to work with and install (cut, bend as needed and join together using sharkbite fittings). I bought everything at Home Depot in Tacoma, WA and installed in March 2015. Fortunately I only did one bathroom which was being remodeled and planned to do the rest of the house later. From the gitgo there has been a plastic taste when the faucets aren't used for a couple of hours. I cannot believe this stuff is still being sold. I will have my water tested and will go from there.
July 21, 2016
Rated 2.0 out of 5.0 by zuul Water tastes like plastic
I did all the plumbing in my house with this.
My complaint is that the water tastes bad from the faucets that have the longest length pipe going to them. You can definitely taste the plastic. The upstairs bathroom water is undrinkable, and you can even smell plastic in the shower when you turn it on. You have to leave the water running a while until you get decent water.
It wasn't too difficult to install, but is more stiff than I expected and tries to go back into the coil shape. For the entire house, there was two leaks that I had to redo. I used the "better" stainless crimps and the tool from HD. Not a big deal, but it scares me because I drywalls over a lot of pipe before pressurizing the system.
April 27, 2015
Rated 5.0 out of 5.0 by KiltedCarpenter Colour Coded
After some experience with the Shark Bite brand of adaptive plumbing connectors, I decided to go to the PEX style of piping when I re-fitted the piping in my single floor 1960s cottage. I used 2 Shark Bite copper manifolds to set up my pipe runs; I was pleased to have cold and hot runs set up so cleanly. You use more pipe doing it that way, but have less connections. Although I still have the kitchen left to do, that will have to wait for the kitchen remodel which is still in the planning stages!
June 24, 2015
Rated 5.0 out of 5.0 by HalRB PEX Pipe
Light and easy to handle. Easy to install. Buy the good crimping tool to make the job a breeze.
July 14, 2015
Rated 5.0 out of 5.0 by Jeff Sharkbite PEX
This is my first time using PEX. Cutting it is easier than I expected. There's no ratcheting cutter needed for this stuff, Buy a decent single-action tubing cutter and you'll be happy. When I cut the tubing originally I don't believe it was cutting square because of the curve of the pipe. The best way to cut it is to lay the tubing in sideways to the curve (if that make sense).
Uncoiling the tubing is a little bit of a challenge. Make sure you leave the wrapping on and uncoil from the center.
April 7, 2015
Rated 4.0 out of 5.0 by Kc8ghn Same as others
Like others said it keeps wanting to roll back up anyway I also wanted pipe insulation on it. Took some work but once I got insulation sled on no trouble sliding on down the pex. Then did it again to but insulation on it took 17. I duct taped the insulation joints together so no pex would show.
May 10, 2016
Rated 5.0 out of 5.0 by sas6015 Excellent product, will buy again
Was not easy for a novice but all you really need to do with this pipe is stretch it out in the sun and let it heat up. It is so much easier to work with.
March 15, 2016
Rated 3.0 out of 5.0 by mike Pex roll review
It is very difficult to straighten PEX that has been in a roll.
February 23, 2016