Rated 3.8 out of 5 by 16
Rated 1.0 out of 5.0 by ChuckB Save your money
I have done pluming repairs for a very long time. Thought I would try it while I was replacing my water heater. Doesn't clean the outside of the pipe and doesn't deburr the inside or outside of the pipe. Use a pocket knife and a piece of sandpaper and save your money. Very dissatisfied.
May 31, 2016
Rated 1.0 out of 5.0 by mjprof Worst excuse for a tool ever.
The tool is almost worthless! It does not deburr well, and in fact left chatter marks that were worse than before deburring. The tool does not do any deburring on the ID either. The depth gauge could be useful. but I found it simpler to use a tape measure. My use was on 1" copper pipe, and perhaps others have had better experience with smaller diameters, but my results were very poor.
May 23, 2016
Rated 5.0 out of 5.0 by Fishooker Makes life easier
Used on Pex pipe to copper tubiing to remove sharp outer edge and chamfer the edge of copper tubing in preparation to install push in Sharkbite fitting as well as a depth gauge to make sure the push in Sharkbite fittings were installed to the correct depth. Made the job easier and I found one of copper tubing's were concentric when the Sharkbite connector would not slide all the way to the mark.
September 1, 2015
Rated 1.0 out of 5.0 by Jay Junk
Doesn't deburr at all , in fact it creates more burrs then a fresh cut with a tubing cutter just use a file .
February 21, 2016
Rated 5.0 out of 5.0 by Thebox Don't install pex without this
If your planning to run pex make sure you use this tool without it your more likely to cut your pipe to short or get a leak . It's straight forward and shouldn't be overlooked
February 18, 2016
Rated 5.0 out of 5.0 by mixmox makes life simple
This makes your life easier when installing pipes. Each socket has at its base a sharp blade which deburrs the end of the pipe with a few twists.
Works with copper and PEX, (probably also PVC but I have not tried that yet)
February 1, 2014
Rated 3.0 out of 5.0 by CoalBaron Ok at Best
As a deburring tool, it sucks. It leaves a rough edge that can damage the plastic collar on the fitting. Do yourself a favor and if you don't have a quality deburring tool, a light touch with a file if necessary, and some 80 grit paper will give you a smooth edge. As a depth gauge, it's fine.
April 29, 2015
Rated 4.0 out of 5.0 by Jimmy Simple to use
You know your installation is correct every time..
May 12, 2015