Rated 3.4 out of 5 by 9
Rated 4.0 out of 5.0 by JULRAL great product, nice look, easy to put up.
The instructions were a bit confusing, but once you start assembly, it was very easy to put up. Be sure to use a rubber mallet and don't hammer too hard to make it fit together or the metal will split.
October 26, 2011
Rated 4.0 out of 5.0 by riverrat sturdy canopy
This is a good, solid canopy. I use it as a boat slip cover and have it attached permanently. You MUST attach all frame pieces together with screws or bolts to use it permanently or wind will pull poles apart.
October 4, 2011
Rated 5.0 out of 5.0 by LarryO Very good product, very well designed
It is designed for a car, boat etc, for vehicles not higher then 6½ '. We have purchased it for a camper trailer - 9' high, so we had to build a 2x6 "pony wall" 30" high. We had to anchor it well to a black top and we are very happy with a result.
See the picture
October 14, 2014
Rated 1.0 out of 5.0 by neveragain dont buy
missing parts. couldn't use the structure for its intended use.
July 14, 2015
Rated 4.0 out of 5.0 by FloridaRV Strong and sturdy
arrived on time , instructions were easy to read, very sturdy and solid equipment. I've raised it approximately 3 ft than standard to cover my RV. So far no issues.
June 30, 2015
Rated 5.0 out of 5.0 by fishingboat18 Best Product ever
Great product, easy to assemble, Have had two Bad storms since I put it up and it has held up under heavy rain and wind. I wish I would have bought it sooner.
May 19, 2015
Rated 1.0 out of 5.0 by Freddy I've Seen Better !
Just received this canopy today and we put it up right away before the rains start again. First off, Quality: Yes, part of the canopy is 2 inch tubing. The metal is real thin gauge and while we were putting the frame together, we found two of the roof support tubes were split. We also found the many of the tubes were out of round and had to be tapped with a rubber mallet so they could be inserted into each other. They do not include any pins to hold the tubes together, so be prepared for the tubes to pull apart when you lift the roof frame up to insert the legs. They sent 4(?) pins to hold 8 legs to the roof structure. They send 8 pins to hold the 8 foot pads onto the legs(?). If your smart, go to the hardware store and buy a few dozen pins to hold the tubing together. And before they say we didn't have enough people, I had 5 people to help hold and lift this in place. Another problem was the top cover: The material is also a thin gauge and it's not big enough to properly fit the roof frame. Sides were okay, but it wasn't long enough to go over the front and back so the Twist Tite tensioning was useless..............definitely not worth the $389.00 !
December 14, 2012
Rated 3.0 out of 5.0 by Optimistic Questionable
This was kinda hard to put together, the ends were a little tight so the. Rope twist thing not good
We will see how it does in this up coming storm
December 11, 2014