Rated 4.4 out of 5 by 12
Rated 5.0 out of 5.0 by MikeS WORKED GREAT
Hard to squeeze out but product works as stated. Used it in the rain and took 48 hours to dry Approx. Then applied pressure and the Epoxy held with no problems.
July 5, 2016
Rated 5.0 out of 5.0 by Chuckles Keeping my posts where I want
This stuff is super strong and sturdy. Used it to set threaded rods in concrete through 6x6 pressure treated beams. Bolted them down after it set up and this won't be going anywhere.
August 17, 2016
Rated 5.0 out of 5.0 by RU Worked just like I expected
There was a little wasted material at the tip before the fully mixed material got there but after that an even mixture was maintained. Setting time allowed repositioning for precise fastener location.
June 26, 2016
Rated 5.0 out of 5.0 by george never used it, yet.....
It is expensive. It looks like it will work great. I have not used it, yet. I had a work around using Titans instead of allthreads. Talk to your building and safety top dog type person and get a waiver. Some of you reading this may know what i am talking about.
April 5, 2016
Rated 4.0 out of 5.0 by SeaWolf Good Adhesive
Adhesive works well, but cartridge has NO shelf-life once opened. After a couple of hours nozzle is clogged from hardened material. Comes with a second mixing nozzle, but after used you're done.
Also you only are supplied with about 3/4 of material in tube, as the piston always stops at this point.
Found this with several tubes used.
January 20, 2016
Rated 3.0 out of 5.0 by HomeMoaner Not much usable epoxy
I was surprised how few bolts I could glue - only about 5 - making it quite expensive per bolt. This is because (a) the mixer-nozzle holds a large fraction of the total epoxy that cannot be then used, and (b) it looks like a caulk tube, but has much less material in it.
If you get this, don't waste too much at the beginning while getting it mixed - of course you need it well mixed, but as soon as it is, start using it.
November 10, 2015
Rated 4.0 out of 5.0 by Csatter Bolt anchor
Bought to anchor bolts in a block wall for a gate. This is one of those things that will take some time to know how it does. If the bolts are stilled anchored in two years it did an excellent job.
I have already used some two tube epoxy tubes. The single tube took a lot of force to get it to come out. It did come with two mixing tubes.
April 28, 2015
Rated 4.0 out of 5.0 by DIYer Solid alternative for DIY
Used to anchor post bolts for a deck. Followed the instructions and the epoxy mixed perfectly. No complaints, had 5 holes to fill, each with 2.5" embedment, figure there was probably enough left for 5 more holes before running out. Looked at the pro level gun that cost 70 bucks and it really doesn't make any since unless you are a professional. For your basic epoxy anchoring needs this does the job.
May 9, 2014