Rated 3.9 out of 5 by 27
Rated 5.0 out of 5.0 by PJ If you can handle replacing a light switch, you can easily install this remote.
Functions exactly as expected.
October 27, 2016
Rated 5.0 out of 5.0 by SouthCarolina Product is as advertised
The product is exactly what it says it is.
A few items:
1. The key pad may arrive set for multiple doors vs a single door. Follow the directions for switching, very easy.
2. Your door may not provide enough power in the wall button wire for the receiver, there is an external power port and a generic power converter works just fine with the right tip.
3. I recommend you hard-wire the receiving unit in up by the garage door opener. Two reasons, A if you need the external power, there is probably an open plug next to the opener and B this places the unit closer to the external door and a shorter signal distance.
September 6, 2016
Rated 4.0 out of 5.0 by HARRY for those of you that need a key coded opener and button it works!
I have a Stanley Garage door opener and it worked on mine, however without the power supply attached to the receiver of this unit it would open and close automatically at random and would not stop. The company CS was available and did understand the problem. I purchased the power supply: on this site SkyLink Model DC-12VGB Internet #205073305
12-Volt DC Plug-in Power Adapter
And it worked properly. I hope you have good success with it as well, but I wish the power supply came with this unit, but some newer units do not need the power supply.
September 21, 2016
Rated 5.0 out of 5.0 by Landon Gets the job done.
The product is obviously built cheaply but all fits seem reasonable and it works like a charm.
October 4, 2016
Rated 5.0 out of 5.0 by matt had to order
Not in stores, but exactly what I wanted.
September 17, 2016
Rated 5.0 out of 5.0 by Ltandrus Works great easy installation
Easy to install. Great customer service! Clerk guided me to the correct item, helped me order it and notified me upon arrival.
August 30, 2016
Rated 1.0 out of 5.0 by RAH Junk
This should've been as easy as changing a light bulb but NOOOOOooooo!!
First the Clamp to go over the existing wires didn't work as designed. The pins inside of it were not centered so did not pierce the wire. SO, as suggested, I cut that off and tried to simply splice the 2 existing wires to the new button unit but it NEVER worked as designed for some reason..
How could something so simple be so useless?!
August 23, 2016
Rated 3.0 out of 5.0 by lee Not compatible with all openers.
I have a very old Genie screw drive opener and this device was not compatible. Customer support was helpful and sent another receiver thinking the first one was defective but the replacement unit had the same symptoms.
Conceptually, this device could be the perfect solution for many old openers but evidently not all of them.
June 28, 2016