Rated 4.5 out of 5 by 14
Rated 5.0 out of 5.0 by Patricia Soffit vent for Cat box enclosure
The vents were a perfect size and were easy to install in hall closet door. The new cat box enclosure to help keep kitty litter off the floor. Easy to clean up each day and the vents provide air flow in / out.
July 19, 2016
Rated 5.0 out of 5.0 by David Looks good, works fine.
Re: Speedi-Products 2 in. White Round Soffit Vent
Fits perfectly in the holes I created in the door with a 2" circular drill saw. I used four of these (which came in a low cost package) to provide the ventilation required to preclude potential oxygen-depletion caused shutoff of the thermostatically controlled propane run icehouse heater I placed in our pumphouse as a backup for the electric heater which is set low to keep the pipes from freezing, in case there's a prolonged electricity outage when the outside temperature is below freezing.
I placed an easily removable flat magnetic-strip house heater-vent cover over the holes on the inside of the door to keep the vent closed under 'normal' conditions, when the propane heater wasn't being used.
February 23, 2014
Rated 5.0 out of 5.0 by OregonHomeowner12313 Makes venting super easy.
Simply use a hole saw to cut a hole, put some caulking on the vent, push it in, wipe off excess caulk. Done!
The only thing that would make these better is if they were friction-fit.
September 1, 2015
Rated 5.0 out of 5.0 by Mark 2" round vent
Easy to install with holesaw bit. Two dabs of silicone sealant secure the vent in place. Unobtrusive; hides in plain sight.
April 29, 2015
Rated 5.0 out of 5.0 by Handeeeman Great product for the need
The product is just as described. Filled a hole from removed conduit in existing soffit perfectly.
December 9, 2014
Rated 4.0 out of 5.0 by EPMC Good for remodeling to get better attic ventilation
Good value for a retrofit, if you're not changing the soffit to perforated. Drill with a hole saw and I recommend a bead of color matched solar seal brand caulk under the lip to permanently hold them up. Not much of that type of caulk is required to make sure it won't come down.
December 11, 2014
Rated 5.0 out of 5.0 by mrgatis Easy To Install
Vents are lightweight and very easy to install on whiteboard by using a 2" keyhole drill. Work well when installed on soffit ends in ventilating soffit.
June 3, 2014
Rated 4.0 out of 5.0 by DIYguy Sturdy plastic, does the job
I installed 3 of these in every other 2 foot section of my eaves. Created a template from cardboard to mark the center of each round vent. Used a 2" hole saw. The 2" hole then seemed a tad too wide resulting in a somewhat loose fit. So I wrapped masking tape around the soffit flange 3-4 times for a snug fit. Seems to help with attic heat - the attic fan comes on much later than it used to.
August 6, 2013