Rated 3.9 out of 5 by 7
Rated 5.0 out of 5.0 by Poeboy53 Condo tight space solution...
Presented with vertical oval dryer vent access tube to outside by condo builder. Purchased dryer at Home Depot and was told installers could only connect to 4-inch round. This adapter, though sold by Home Depot, was not part of the typical venting kit sold with dryers. This piece resolved the dryer vent installation issue perfectly.
August 9, 2016
Rated 5.0 out of 5.0 by Bruce 4 in. Plastic Round to Oval Adaptor
I have a new townhouse. In order to hook the Dryer up I had to find product that had a 4 in. round connection on one end and an Oval Adapter on the other end. The house Dryer vent line had an Oval shape. The store rep in plumbing helped. This product had to be ordered and it fit perfectly.
October 27, 2015
Rated 5.0 out of 5.0 by Bubba61 Works Great!!
This adapter makes it much easier to get the hose connected than trying a round hose fit an oval fitting.
July 28, 2015
Rated 5.0 out of 5.0 by Shopper hard to find
More and more dryer vents require an adaptor to connect to the outside vent. This product accomplishes that task.
March 3, 2015
Rated 1.0 out of 5.0 by awesomeguy doesnt fit
Does not fit at all, stuck using duct tape most useless item i ever bought
February 3, 2015
Rated 5.0 out of 5.0 by MHS70 In case you're not sure what it's used for...
I had to go out on a limb and buy this and hope it served my purpose. So I'm writing this review to tell you what it is in the event you're wondering also.
I had to get a 4" rigid dryer vent pipe in a 2x4 stud wall. This is the product to help you do that. On one end, it takes a round 4" rigid vent. On the end that goes in the wall, it also takes a round 4" rigid vent but it shapes it in an oval form so that it fits within the wall. As your 4" pipe travels up in the wall; however, it will go back to the full round shape again - so I'll just have my drywallers squeeze the pipe as they install the drywall.
You should be aware; however, that your local codes may not allow for a deformed pipe.
I would strongly recommend using a 4 1/2" clamp to secure the horizontal and vertical ends of our pipe to this adapter.
May 23, 2012
Rated 1.0 out of 5.0 by unhappycustomer Did not fit
The conversion piece did not fit very unhappy I had to force on a different piece
February 26, 2013