Rated 3.1 out of 5 by 13
Rated 4.0 out of 5.0 by emoritz Easy to install and use
Easy to install and use, be careful not to over tighten.
March 18, 2014
Rated 2.0 out of 5.0 by RA07 Flat shoe good;angled shoe not so much
We purchased flat shoes for the level bannister and angled shoes for the staircase. The set screws in the angled shoe made the shoe ride up and become unstable. This is a design problem that caused our carpenter to be required to re-tap the set screw holes from the side instead of the front of the shoe. This was an expensive fix in labor and time. The angle shoes need to be redesigned to eliminate this defect. If I had known of this issue, I would have selected a different product the defect is not apparent until the banisters and spindles and shoes are cut and in place and ready for final set screws. In other words not until it is too late and way too expensive to change course.
April 30, 2015
Rated 3.0 out of 5.0 by misterfixit info
i found out the set screw is a T15 star bit not an allen wrench size!!
June 30, 2015
Rated 2.0 out of 5.0 by Rick Not impressed.
The hex head on the set screw stripped on more then half of the 24 I purchased. I had to grind down a small screw driver to make them work.
September 23, 2014
Rated 5.0 out of 5.0 by Jaye Easy to install
We decided to redo our stair rail...easy to install, price was better online than in store....we had to order extra because at first we were only putting them on the bottom, than decided to place on top also....2nd order came quickly and we finished the project...i love the stairs!!!
April 30, 2014
Rated 5.0 out of 5.0 by majmike Just what I needed
Installing new balusters. Shoes were precision made and kept balusters in place while hiding my "imperfections."
July 22, 2014
Rated 1.0 out of 5.0 by Doug Screws are very poor
I bought over 200 of these and at least 1/3 have a screw that strips out as soon as the first turn is made making the shoe unusable since the screw won't come out far enough to allow the baluster to fit inside. The others that didn't strip immediately did not allow firm tightening and would strip at that point. Had to caulk each one so it would stay in place. Very poor - definitely use a different shoe.
March 23, 2013
Rated 4.0 out of 5.0 by railinstaller1231 Nice Piece But Make Sure You Have Correct Allen Wrench Size
I recently used these to cap off my iron balusters on a newly installed railing. They look great and appear to be well made. My only complaint is that my standard Alan Wrenches did not fit the set screw. Luckily I found one that fit reasonably well in my junk drawer. It would be nice if they manufacturer would tell you what size wrench you need since it is not a standard size.
January 29, 2013