Rated 4.1 out of 5 by 53
Rated 4.0 out of 5.0 by Customer Great stairs!
Very easy to work with and a great quality stair tread.
March 3, 2016
Rated 4.0 out of 5.0 by Sedge Solid piece of oak
I didn't need a star tread. Instead I needed a good solid heavy piece of oak ant this met my needs very well after a couple of cuts. Nice straight grain and well planed wood.
March 1, 2016
Rated 4.0 out of 5.0 by Pdi Really Nice Looking Stair Treads
I tried to figure out ways to most easily and cost effectively spruce up my old, painted basement stairs, and finally decided that replacement would probably be the best compromise between cost, quality and ease, and these oak treads seem to offer just that: They are really nice looking. I think they'll go in fairly easily, and what's not to like about oak?
February 13, 2016
Rated 3.0 out of 5.0 by Darryl Red Oak Tread
2 of the treads cracked when putting in the screws. I still used them.
I think next time i would use
1 1/2" to 2" thick instead of 1".
February 23, 2016
Rated 5.0 out of 5.0 by RonV Why spend more, these treds are great quality.
Since you have to sand and stain them anyway, why would anybody pay twice as much for "1st quality". These treds are very very nice, after proper prep ther is no way you could have a better outcome. The one thing I will say is get a couple more than you need, I needed 12 and bought 14 just to have more grain patterns to choose from (and I'm glad I did), I returned the 2 that I did not choose at my local store. I pulled my old treds off, painted my risers and installed my new stained and finished treds and my finished project is way nicer than I imagined, what a great bang for your buck upgrade.
March 27, 2013
Rated 1.0 out of 5.0 by calhardwood This product has some problems!
This product is made of up to 7 pieces of glued up strips of wood...beware. If you are looking for a clear select product this not!!! for you. It is made of a number 1 red oak that has tons of color variation in the piece and dark mineral(black) is the normal. Also the bottom has glue and wood voids that do not allow you to leave this exposed. On one of ours it went all the way to the edge that you could not finish the end due to wood voids. This is a rustic wood product and the description should be accurate.
August 21, 2013
Rated 5.0 out of 5.0 by Richard Good quality, great value, timely arrival
Of the ten treads I received, only one had very minor worm holes (1mm size and only a few, not a problem). A quick, light sanding with 100 grit, followed by three coats of urethane (sanding with 220 grit in between) created "perfect" oak stair treads.
February 14, 2012
Rated 5.0 out of 5.0 by packrat001 Great value!! Much better than ALL competitors!
I read the reviews and checked prices at other stores and websites (including Lowes). This was the best deal of all. I ordered 15 treads to make certain I had enough without defects to use (based upon the other reviews that indicated some treads were not usable on EITHER side). There were a couple that could be used either side, but the remainder had significant flaws on one side - that could not be corrected by sanding. However...the "good" sides, with little sanding, came out perfect! I could use ALL the treads delivered. These are classed as "builder grade", but I'd say, if you only need one side (as in most applications), buy this product and save a LOT of $$$$. I applied construction adhesive to bond the treads to the rough-cut treads I found under my existing carpet. (I was replacing a carpeted stairway with red oak.) Using a rubber mallet, I seated the treads and they have bonded permanently to the stair framework.
February 26, 2013