Steel City 6 in. Cast Iron Jointer -DISCONTINUED-40540 at The Home Depot
Free shipping

Steel City

Model # 40540

Internet # 204766618

6 in. Cast Iron Jointer -DISCONTINUED

Steel City 6 in. Cast Iron Jointer -DISCONTINUED

This item has been discontinued.
The Home Depot no longer carries this specific product.

$644.99 / each
Item cannot be shipped to the following state(s): AK,GA,GU,HI,PR,VI


In Stock



Model # 40540

Internet # 204766618

The Steel City 6 in. Jointer comes with a powerful 1HP motor which drives the 3 HSS knives with large 46 in. cast iron bed and 26 in. adjustable fence. The other great features include 4 in. dust chute, large on/off paddle switch, 2 rubber gripped push blocks and stand.

  • Powerful 1HP 120-volt motor
  • 3 straight knives HSS cutter head
  • Large 46 in. long cast iron bed and 26 in. fence
  • Fence pivots to 45, 90, 135 degrees

Info & Guides

You will need Adobe® Acrobat® Reader to view PDF documents. Download a free copy from the Adobe Web site.


Amperage (amps)  4.2  Assembled Depth (in.)  46 in 
Assembled Height (in.)  38 in  Assembled Width (in.)  12 in 
Bench & Stationary Tool Type  Jointer  Bench or Stationary  Stationary 
Certifications and Listings  No Certifications or Listings  Color Family  Gray 
Depth Adjustment  Yes  Depth Measurement System  Yes 
Dust collection type  Port  Manufacturer Warranty  2 years with Registration 
Maximum Speed (rpm)  5200  Power Tool Product Type  Bench & Stationary 
Product Depth (in.)  12  Product Height (in.)  38 
Product Weight (lb.)  125 lb  Product Width (in.)  46 
Reconditioned  No  Returnable  90-Day 
Voltage (volts)  4.2 


Rated 4 out of 5 by 1 reviewer.
Rated 4 out of 5 by Very Good Product I got this jointer about three weeks ago. I just started using it because the jointer needed to be put together and the instructions for doing so were not very good. The pictures in the manual were very hard to see any detail so it just took extra time to make sure everything went together correctly. When I turned it on the first time the motor started however the belt would not turn the cutter. I removed the cover which covers the belt and then tried it again, it worked fine. I am unable to move the motor enough that the belt will not rub against the cover so I am running it without the cover. I ran several boards through it and this works well with the exception of the end which snipes a bit for an uneven ending. Cannot seem to correct this problem yet. I have not used it enough yet to give a full review. February 25, 2014
1-1 of 1


Standard Shipping includes delivery by small parcel service. Processing time varies by product.

If product is eligible for shipping to AK, HI and US Territories additional transit time and remote surcharges may apply.