Rated 4.4 out of 5 by 23
Rated 5.0 out of 5.0 by JUSTTRYIT LESS IS MORE
We replaced two Sunstat programmable thermostats (each had died after 3 yrs)...the high-end way over-engineered model that does everything except start the coffee pot. All we wanted was a simple "senior model"...on/off and up/down (temp). I did the installation myself. At purchase, I bought one extra (on advice of my sister) and, sure enough, one was faulty. Saved me an extra trip to Home Depot in the middle of the install. Despite that glitch, it's a great value and just what we wanted. Home Depot refunded on the faulty one, no problem.
August 13, 2016
Rated 5.0 out of 5.0 by KAG Sunstat non-programmable floor warming control
Product looked good, liked the digital upgrade. Easy to install and use.
August 16, 2016
Rated 5.0 out of 5.0 by D123 SunStat floor warming control
I installed the heated flooring and had my handy man electrition connect it. I did the testing required several times during the laying of tiles. All works perfectly. I recommend this product
July 12, 2016
Rated 5.0 out of 5.0 by Hhgmht Thermostat
As I've only had this for about 10 days it is virtually worthless to review. Yes it works, can't vouch for how well it will work 6 months from now.
May 10, 2016
Rated 3.0 out of 5.0 by Kicken Warmth
Works fine but wish I had splurged for the programmable unit. Floor takes up to 30 minutes to feel heated difference, and my showers are short.
May 4, 2016
Rated 5.0 out of 5.0 by SteveVA Simple, easy to use
I recently installed a SunTouch mat in my bathroom floor. I originally wanted to use a timer switch but soon realized these thermostats are needed to regulate power to the mats.
I mounted the thermostat in a deep single gang box. It was just enough room for 6 inches of 12 gauge wire, the sensor wire and mat power wire. Instructions are easy and clear. I do wish they organized the hot/neutral wire set up on the back but I just read closely which was wired to which.
Operation is simple, turn the dial to the temp and flip the on switch. The GFCI test is easy to operate as well. The floor takes about 10-20 minutes to get 'warm' and longer to get 'warmer' so in that sense, I wish I got a programmable one. I turn the floor on when I wake up... my wife turns it off later after she showers.
One note: I ran a new 20 amp circuit for my heated mat. Before the thermostat I installed a 20 amp GFCI outlet. I did not wire the thermostat as a load off the GFCI outlet as the thermostat is GFCI too and they would both trip each other. I just pigtailed the GFCI onto the load. My mat draws 1.5 amps and my wife's blow dryer just below 15 amps so the circuit is around the recommended 80% max draw. No circuit breaker trips yet.
February 12, 2016
Rated 3.0 out of 5.0 by Frustrated SunStat 120-Volt/240-Volt Non-Programmable Floor Warming Control
Seems like every produce has some kind of flaw. The one I received was difficult to install. The screw that holds the sensor wire in was too short to hold it properly. Took about an extra hour to remove the short screw and put an unused one in its place.
January 1, 2016
Rated 4.0 out of 5.0 by Nick Gets the job done but overpriced
The product looks clean, installed easily, and does what it was put in place to do however I believe that it is overpriced for what it is.
September 5, 2013