Rated 4.1 out of 5 by 10
Rated 5.0 out of 5.0 by DIY The most important part of your mitigation system
I built a DIY Mitigation system and used a similar fan. Had I known Home Depot offered this fan kit, I would have purchased it instead of going with Amazon, as I always trust Depot's products (and like that I can return it without having to do a return shipment!)
Anyway, I detailed my experience with an inline radon fan in this post
Positive experience and it actually works.
July 11, 2016
Rated 4.0 out of 5.0 by zman Decent Radon Mitigation Fan
I'm a do-it-yourselfer and was able to change out my old radon fan with this one. The instructions were clear. This fan gives me a suction reading that is lower than my old one, but that might be how I have it hooked up. I'll have to see if I can check for leaks as the weather improves. I had an existing gutter as the vent, so better performance might come from using a PVC vent instead. I'll have to experiment.
March 24, 2015
Rated 5.0 out of 5.0 by dechem222 Quiet, easy to install, does a good job
Our house had a radon reading of 5.0 so we installed this fan to ventilate the crawlspace. Glued the moisture barrier together to form the membrane (did not seal at walls) and ran sch40 pipe under membrane with end plunged about 18" into a hole in center of crawlspace. Fan was installed outside with lighter-weight DWV pipe above the fan and anchored to wall with gutter clips. Within two weeks radon level had dropped to 1.1. Noise and vibration are hardly noticeable!
February 6, 2013
Rated 3.0 out of 5.0 by FlipperHH OK
The fan was fairly easy to install but the couplings that were included with the fan were much to large (6"). I was in the attic laying on insulation trying to get the fan positioned and fastened to the pvc ductwork when I saw this. I had to crawl back out of the attic, clean myself up and hike over to the hardware store to buy the proper connecters. Took at least 1-2 hours longer than if the propper connecters would have been included in the carton as advertised and cost an extra $15 to boot.
February 15, 2012
Rated 4.0 out of 5.0 by bg61 fan is good - "deal" is not, just less stuff
The fan is easy to install and runs quietly. Thumbs up for that. Unfortunately, the online "kit" does not include the air pressure indicator shown in the picture (it is included with the store kit hence the price difference). My bad for not reading the caption thoroughly but the display is misleading. Note that the indicator is not available separately so unless you are replacing an existing fan, the store kit is a better choice.
January 3, 2012
Rated 5.0 out of 5.0 by Ronnie This product was easy to install, runs quite, and was economial.
Outstanding product. Replaced another louder model. Easy to install with the instructions provided.
May 22, 2013
Rated 1.0 out of 5.0 by fanguy Not enough specifications provided
I cant believe you dont provide any detail of the performance specification for the fan, CFM and static pressure
March 1, 2013
Rated 5.0 out of 5.0 by paris289 Everything came in 1 box that I needed to install this Unit.
This radon fan is quiet, easy to install. It cam with brackets for mounting and a convenient way to wire the electricity to it.
February 10, 2013