Rated 4.3 out of 5 by 7
Rated 4.0 out of 5.0 by Mike Did the job
The kit has what I needed. I could not get the hot water seat out even using the seat tool. But I only needed to replace the cold water seat so it worked out for me.
July 27, 2016
Rated 5.0 out of 5.0 by CPM Ordering the part through Home Depot
Ordering over the internet and the overall process for pick up were easy to follow. Thanks!
It is supposed to stop a shower faucet leak.
Which will be performed as soon as time permits.
July 16, 2015
Rated 5.0 out of 5.0 by Jeff necessary updates
Time for replacement. Water leaking, diverter hard to move, everything acting strange. Rebuild the shower assembly. Easy and quick. Everything good again.
March 4, 2015
Rated 2.0 out of 5.0 by RayG Easy to install but comes with a hitch.
The components in this kit are made from high quality materials and are easilly installed. However, the large sealing washer is held in place by a ring that is not referenced as being threaded and appeared to be pressed onto the valve.
You can see what happened next-I used a punch to remove the ring then said oops! Luckilly I was able to clean up the threads and install the new ring without drama.
It's been two weeks since I installed the parts and the washers are taking seat, decreasing and eliminating the slight drip into the tub that occured with the fresh washers installed.
October 11, 2011
Rated 5.0 out of 5.0 by greenifpossible cost effective way to stop drips when the seats are still good
this kit supplied the washers and hardware needed to rebuild the cartridge of a temptrol water valve. it came with instructions, that are also downloadable from the symmons site. visually inspect the seats and shake the cartridge to make sure the piston moves freely. if these are ok then chances are this item will fix dripping after shutoff, and the valve will be ready for service. while disassembled consider readjusting the hot water limit screw if you also wish to raise or lower the warmest temperature possible with the valve.
August 1, 2012
Rated 4.0 out of 5.0 by Cd Photo is incorrect
Photo shows two o-rings that are not in the kit. Simmons documentation indicates 5 pieces, which do correlate with the parts in the TA-9 package.
June 27, 2014
Rated 5.0 out of 5.0 by newbeeplumber Don't bother with the knockoffs. Peace of mind with the factory parts and fit.
Don't bother with the knockoffs. Peace of mind with the factory parts and fit.
April 30, 2013