Rated 4.3 out of 5 by 9
Rated 4.0 out of 5.0 by FixItMyself Good Product
Takes a long time to melt as others have noted. Plastic handle & pour spout becomes pretty much permanently attached to can, so do not expect to use another time. If you have many cracks to fill it will take you longer than the product will stay liquefied....despite carefulness, drips from spout onto can make reheating difficult - your heating source will be subject to dripping liquid rubber. Also, wear gloves when using, very very very hot
August 9, 2016
Rated 5.0 out of 5.0 by RLS Great product!!!
Bought the kit with one can. Worked so well bought the two can refill kit. Works better on road cracks than anything we have ever used. Really easy to use. After pouring into crack, used propane torch to melt sealer to smooth out flow. This is an amazing product!
February 4, 2016
Rated 4.0 out of 5.0 by Rich Use all driveway crack repair
I found the product to be very good. While heating the product the seam on the can leaked allowing the sealer to run onto the stove causing the spilt product to catch on fire. I was using a gas burner outside and was able to guickly extinguish the flame. The second can worked fine with no leak. The product is more difficult to work with than the cold type sealers, but the end result is much more permanent. If I did not have the difficulties with the first can leaking the quality and overall rating would have been excellent.
September 29, 2015
Rated 4.0 out of 5.0 by FormerContractor So far so good
Takes a little bit to heat it up (used a 2-burner Coleman stove with HD foil around the can to hold in the heat) but I expected that after reading the reviews and the outdoor temp was only 50F. Once liquefied it poured nice and was easy to work with. Seems to be very sticky and flexible so if it holds up I'll be happy. Be sure to wear leather gloves when doing the heating and work to keep from getting burnt. Just ordered two more kits to finish the job.
October 23, 2015
Rated 4.0 out of 5.0 by homer931 good sealer bad packaging. Broken handle
sealer works good. You have to heat up outside and poor into cracks.
My pack came with a broken handle.
October 20, 2015
Rated 5.0 out of 5.0 by fuss1 Works really well for sealing cracks
This product works really well for filling and sealing cracks. Time will tell how well it holds up but I'm thinking it will be okay. I've had to order three refill kits to fill the cracks in my driveway but that's okay. The amount you receive never seems to go as far as you expect but overall I'm okay with that because I'm happy with the product so far. I expect this to last. I think this will hold up better because it's flexible.
I bought a cheap little butane camping stove and butane cans from Amazon to heat this product up and that worked well although it takes some prep time to get ready. I think the prep and application will be worth it in the long run. I ordered the stuff online for in-store pick-up three times and two of the boxes that the product came in were fairly brutalized but the product was okay. I would recommend this for sealing asphalt cracks.
June 14, 2015
Rated 4.0 out of 5.0 by 69chevy So far the best i have seen
Did not give the product an excellent overall rating because of the heating process. I knew purchasing it that it would be difficult heating it up, that is definitely the case. It did fill some rather large cracks and gives a nice layer of protection around the crack. Adheres very well, the test of time will be the deciding factor, but after 3 weeks the latex based crack fill would already have been cracking with the temperature swings we have had here in the north east.
August 26, 2014
Rated 4.0 out of 5.0 by AFCHOG 500°F - That's the secret
Followed all the instructions but found that in order to turn the solid into a liquid that could be applied I had to heat the product to 500°F, and the only way I could do that was to close the lid on my propane fired grill. Even at that temperature only a portion of the product liquifies. Apply that portion, and then put the can back on the fire.
I bought the kit because I believed that the handle assembly would be the safest way to use the product, and it definitely works until you close the lid to achieve the higher temperature, then the handle melts.
I ended up using a pair of pliers to pour the product, and got pretty good at it.
BTW - and this is IMPORTANT, ended up ruining my grill.
Even before the lid closing, the seams on the cans would ooze the product into the grill.
Hey, my wife is happy, she's getting a new grill next season!
And, here's the thing - the product works great! Just be ready for some mess, and don't use a newer grill!
October 28, 2014