Rated 3.9 out of 5 by 9
Rated 4.0 out of 5.0 by youwantaname easy application and easy clean up
applied to interior doors laid flat and it is self leveling product that covered in two coats.
just keep in mind that this product does not go as far as others.
when I used minwax polycylic in the past it wasnt as easy to achieve a run,puddle free application as this
varathane product, but the other product went farther and did 3 coats on two doors - front,back the edges and enough to do the trim.
this varathane did two coats front , back on the doors and it was empty. the front and back look great.
I have some of the other left that can finish the edges that are still raw. [undone]
I will need to get more varathane to cover the trim.
October 8, 2016
Rated 5.0 out of 5.0 by ckoshawa Good stuff
I used this product on my outdoor table and it's looking great... It does get a white hue when it is soaked in the rain but there is nothing to worry about because it disappears as it dries just like my indoor varathane diamond finish.... Dries quickly sands smooth, really easy to use.
August 15, 2016
Rated 5.0 out of 5.0 by Artist Loved it
This worked very well for my urethane needs. Awesome!
March 12, 2014
Rated 5.0 out of 5.0 by Dranch Clear Satin Water based spar
Used on exterior sign for the ranch entrance gate and will see how it holds up compared to oil based products sold from the past. Spread ok and dried looking great. If they could print the instruction lable a bit larger it would help, dang near need a magnifying glass to read this lable!
February 10, 2016
Rated 4.0 out of 5.0 by Andy Stands up to its purpose
I used it to protect a workbench I use indoors and outdoors. The product behaves exactly like the labels says. I used a brush and my Wagner HVLP system. The product has tendency to foam if you over apply it and work it in difficult places with many edges and small surface - HVLP system is the way to go. I applied the product in the middle of Arizona hot summer - and I don't recommend you do the same if you want the clearest possible finish. The product tends to have milky appearance when you apply 4 coats with a brush and at room temperature. Note that this finish stays somewhat flexible when fully cured - so, it will mark when you hit it with a solid object.
August 5, 2014
Rated 2.0 out of 5.0 by Darren Not good for my application
This stuff has no odor and cleans up easily. That's about all the good I can say about it.
I bought it to seal wooden arrows shafts with. It took 4 coats to finally keep the dye on the shafts from bleeding through. I put on a total of 7 coats by dipping the shafts in a tube and letting the excess run off. After drying completely, the urethane had kind of a rubbery feel to it and could be easily scratched.
After I was finished with the shafts, I took them off my drying rack and put them on a table to work on later. When I came back to them the next day, they were all stuck together. Now I am going to have to strip all this stuff off and start all over again using something else.
July 15, 2014
Rated 1.0 out of 5.0 by Woody Looking for a quality finish....... Keep Looking!
If you’re looking for a quality finish....... keep looking. This product is a waste of your hard effort. I was looking for a solid product to finish an outdoor project and tried this product..... what a mistake! This JUNK will not lay flat and leaves your project looking like a mess. I tried to spray it on and I tried to brush it on with no success. If you’re looking for a product that will bolster the ego of your four years old and their finger painting project..... You've found it, but if you’re looking for a quality finish, keep looking!
April 19, 2015
Rated 5.0 out of 5.0 by WillSellAZ Clear finish
Purchased this product to go over stain on a fiberglass door that faces West. It is rated for outdoor use. It went on easy and dried clear as labeling noted. The product is not suppose to yellow. Only time will show durability and years between application.
June 9, 2015