Rated 3.5 out of 5 by 27
Rated 3.0 out of 5.0 by Papa Hard to use but worked
It did cut the holes but because it has only a couple cutting teeth it jams more and jumps off the project. It did work but not very smooth.
March 22, 2016
Rated 5.0 out of 5.0 by Dragon68 Quality product
Very easy to use. Slid it into my electric screwdriver/drill and cut easily through my desktop with a clean edge. The plastic wire pass thru fit perfectly in the holes. Very nice product.
December 14, 2015
Rated 1.0 out of 5.0 by ca Hole saw is no good
hole saw did not work.
i have been back and exchanged the first one thinking it was just that one.
I wish i purchased something different.
December 8, 2015
Rated 5.0 out of 5.0 by Chico Quick change of hole saw that performs satisfactionally.
When I saw this product, I thought it is to flimsy to work and will not hold up. I was wrong. It cut through food, siding, drwall, and is still sharp.
December 20, 2015
Rated 2.0 out of 5.0 by Jonnyboy not that great
I'm actually trying to return this. I couldn't find my hole saw so I went out and bought this one. drilling through a 1/2" piece of pine was dreadful. the 2" hole saw bounce so much it came out to a 2 1/4" hole. Maybe I did something wrong
September 29, 2015
Rated 5.0 out of 5.0 by SDNsinBillings Carbon hole saw set with mandrel
Like it but wished I could buy one hole size at a time. Replacing an old one that wore out.
July 21, 2015
Rated 1.0 out of 5.0 by PNWer You get what you pay for, I guess.
These might be fine for drilling through hollow core doors and the like. Alas, for wood, I only made it through 2 and a half holes before the locking nut that holds the hole blade to the drill bit completely broke. The entire set is dependent on a tiny hex-lock nut. It's a terrible design.
So, I figure it cost me about $5 a hole.
March 8, 2015
Rated 2.0 out of 5.0 by Donmark144 Dull
I didn't care for this bid it took a long time to cut into the wood. And when it did it suddenly slam down into the wood and was not easy to manage. The one positive is the way the slots are cut on the side makes it possible to view the inner bit easily
February 28, 2015