Rated 4.0 out of 5 by 67
Rated 5.0 out of 5.0 by Bruce Logical Choice for Furnace Replacement
I chose this as a logical choice for heating my river front cabin. The furnace in place was aging and becoming unreliable and needed to be replaced. I chose an unused closet wall for installation and it has worked well. I felt that the installation instructions could have been described better and more information on sources for the extra hardware required could have been provided. I.E. I was not advised about the Williams chimney starter kit and where parts would be available
September 7, 2016
Rated 3.0 out of 5.0 by Nash The good,the bad, and the ugly and all the above
I bought this heater to replace a very old wall heating unit TEMCO that was leaking gas and carbon monoxide. The installation supposed to be quick and easy, but I still decided to hire a professional HVAC tech. However, it was nightmarish.
It was very hard to fit the unit into an existing wall whole so I had extra expenditures on boards, insulation and spacers. The small over-heating sensor was mounted on the side of the unit and techs accidentally damaged it during installation, so needed to be replaced with a new one. Came with a cheap and BROKEN thermostat so I ended up buying a new one and paying extra for installation...thanks to Home Depot Customer Service that gave me partial credit for that.
After installation the unit seemed to work fine except the noise. During the heating cycle the unit produces the normal sound( white noise) but after the temperature has been reached you can hear the clicking and nocking sounds from the chamber and the vent. Called the Williams Customer Service and they explained that this is normal-"metal is cooling off and the noise you hear is the trunk lines and chamber cooling down..'. So,since I sleep in that room -I better get used to the noise.
April 21, 2015
Rated 5.0 out of 5.0 by Dayo Great purchase- warms my heart, my toes and didn't burn up my checkbook balance!
My previous wall furnace was already hooked up to a chimney for venting, so it only took a few minutes to undo the previous gas line to pull out the old, and this new one was the exact same measurements and looked to be nearly identical in every way, so reinstall was a snap for my brother.
It took him an hour and a half to put this in, and because of newer connections when I got a whole house furnace handling the upstairs of my house a few years ago, they put in the venting at that time so, I did not need any extra parts as some stated they had to get for a complete connection and to get it up and running. That was a priority to check out since so many complained of that issue...so install day went well with that knowledge.
Its been in for a month now, and all seems to be working perfectly...and I hope it continues that way. The other it replaced was there for 35 years, and my brother said this one is actually made from better materials in the combustion chamber area. And I love the thermostat instead of having to crawl around on the floor to adjust the temp, just using the wall thermostat was a huge upgrade!
December 10, 2014
Rated 5.0 out of 5.0 by carter monterey furnace 35000 btu
furnace fit right into same hole the other one came out of. had to reroute gas pipe. fired right up
and is working perfect. the only down fall was should have ordered it in summer when I new furnace was bad it cost me an extra $100 right before winter and back then it was free shipping to house I could only pick up at store for free.
February 10, 2016
Rated 5.0 out of 5.0 by Tcarter Works great!!!!
Works great installation wasn't to bad and loved the fact that Home Depot had the PDF of the instructions available online before I purchased
February 10, 2016
Rated 5.0 out of 5.0 by Bobkirby Nice unit
Replaced a 30 yr old heater in a rental unit with the Williams Monterey wall heater, works great!
January 6, 2014
Rated 4.0 out of 5.0 by GoodDad Good Value for the money
We own a seasonal summer cottage in Minnesota. We shut it down for the winter. I shopped around and bought this one to replace the old wall furnace of similar dimensions. To heat the place (800 sq. ft.) on cool autumn days & nights, it does a fine job so far. It has to be alot more energy efficient than the 50 yr old unit, right? How long it holds up remains to be seen (planned obsolescence?) I bought the blower accessory too, which is noisier than I had hoped, and underpowered compared to my last furnace. I place a portable fan nearby to move air more forcefully. The installer said it was not difficult to work with including lp conversion. I also bought a thru the wall fan which I'm very happy with too, and is in the photo (if it uploads). There was a manufacturing dent on the access panel which I was able to easily fix. I had a problem finding attic vent pipe. Home Depot does not offer it. I found Amerivent brand type B vent pipe at another home center via special order. Summary; so far, I'm happy, but longevity remains to be seen. I'll report back in a few years.
November 8, 2012
Rated 5.0 out of 5.0 by Willy I like it
Great buy fit right in took me about 2 hours to install. Heats the house better than I thought it would.
January 1, 2016