Rated 4.9 out of 5Â by 23
Rated 5 out of 5Â by 10andagame Excellent instant on ballast
I read the reviews prior to purchase as I have not had good luck with fluorescent fixtures in the past. The T8 replaced 2 old ballasts each twice the weight, and 4 times the uselessness. First I removed one ballast and fit the new one in the old location with the same retaining nut. While narrower and lighter, it fit the same slot. I cut the wires from that ballast first and attached by color to the new one. Then followed with the second. Not hard. The instant on with no flicker or hum is outstanding. I did all three fixtures in my basement with equal success. Highly recommend.
May 26, 2014
Rated 5 out of 5Â by HDregular Worked very well
The replacement ballast was an exact match in terms of size and wiring to the existing ballast. It installed very quickly and easily and my kitchen light now works like new.
October 14, 2014
Rated 5 out of 5Â by Lou99 Replaced T12 ballast
First time changing out a ballast. Turned out I had T12's with two ballasts and alot of intimidating wiring. After watching how to videos I installed this very easily and it works perfectly! Very happy with this product.
April 6, 2014
Rated 5 out of 5Â by GladMech T8's excellent upgrade for T12's
I am gradually replacing my T12 ballasts as they fail. I will eventually have replaced several dozen ballasts. I have trouble with some T12's when too hot or too cold.
1. These fit in the same fixtures.
2. The wiring is not the same, but easily swapped.
3. The bulbs are smaller and lower wattage.
4. The light output is higher.
5. The expected life is longer.
6. The range of acceptable temperature is wider.
All in all - better in every way.
January 15, 2013
Rated 5 out of 5Â by Brad Economic fixture rebuild upgrade.
I was asked to change a dead ballast. All 4 tubes had dark ends and both ballasts were the same age. This single ballast only costs $4 more than a 2 lamp ballast, is more efficient and so is upgrading from t12 to t8 tubes. The ballast is a high voltage start, so you tie both socket pin wires to only one ballast wire. The lights start fast, are brighter than t12, and 4-23w bulbs on 1 high voltage start electronic ballast draw 1/2 of 4-40w tubes with 2 filament heating ballasts and eliminates call backs for the other ballast.
August 25, 2013