Rated 4.2 out of 5Â by 63
Rated 3 out of 5Â by chip Chips Great - Pull / Recoil Starter Broken from Factory
Upon delivery 9/6/2014 the unit checked out and seemed fine. I assembled it added oil and gas and made sure everything was tight and ready to go. Since it was a new engine and I knew it did not have a throttle setting I decided to leave the start switch off and give the unit a few light pulls to cycle it before just running it at max rpm. Upon the first light pull of the recoil starter it made a click / clack noise and did not engage the motor. Upon the second light pull the recoil starter simply spun around again without engaging the motor. The third time I pulled it very slowly trying to see what the problem was and the plastic spool that holds the rope fell off inside the cover and the steel spring popped out and uncoiled. WOW off to really bad start. I removed the cover to find that the main "shaft" bolt that holds the entire recoil starter assembly together was obviously over tightened resulting in it sheering off, which had to be obvious to the person assembling it, but it was installed anyway. At that point had I not already put gas and oil in it I would have loaded it up and taken it back to homedepot. BUT too late. I removed the cheap plastic and soft metal parts of the recoil starter and replaced the cover so I could start it with the electric starter and see if it would cut, which by now I was having serious doubts about quality. It took a bit of time to get it started. Once started I chipped a very small pile of branches and it seemed to do well, but that was only a few minutes of operation. SO now I must call / email GXI and request a completely new recoil starter and the metal external cover because the bolt that they sheered off goes into the back side of the cover which is all one piece. I expect much higher quality from a $1,400 piece of equipment and especially a recoil rope starter that has to crank a 420cc engine. Seeing the cheap, soft "gold" tone metal parts inside the unit really has me worried about the rest of the machine. I will rate this thing better if it performs well in the next few weeks and if GXI gets me a new starter ASAP......It's funny when I decided to buy this one I was worried that the electric starter was just a gimmick and would not work well on such a big motor, but it seems very powerful and cranks the motor quickly, maybe that's why GXI / Stanley decided they could use a cheaply made poorly assembled recoil starter unit?
September 6, 2014
Rated 4 out of 5Â by lebeaubamboo Powerful and sturdy but has trouble with some wood
The product runs well and is very easy to start, however it came with a defect in the chipping mechanism. When we first used the machine it would not chip branches in the side chute but instead would just grind the end. After taking it to a repair shop we learned that the blade was positioned incorrectly and Stanley had this fixed promptly. The blade still doesn't seem quite right because it pushes branches away instead of pulling them in which increases the amount of work and time required to go through a pile. Additionally, we often end up with a lot of wood pieces left over that are too short to maneuver around the blade. Stringy wood such as Quince are particularly difficult to chip while others such as Walnut go through with far less effort. It's hard to say if this is how the chipper works as designed or if the blade is still angled incorrectly.
Even so, in eight hours of chipping we covered around 1,000 square feet several inches thick. We're happy that it handles bamboo canes well, bamboo is very fibrous and clogged some of our past chippers. We've chipped bamboo canes up to 3.5 inches in diameter and thirty feet long in as little as 60 seconds, whatever blade issue we might have doesn't seem to affect cutting bamboo.
The chips blow lightly out of the shoot instead of blasting off in every direction which means we actually get to use the chips. We had a chipper that shot the chips out of a similar shoot to this machine's, but they would the ground and fly a good fifteen feet away which prevented us from gathering the chips for use elsewhere.
August 3, 2013
Rated 4 out of 5Â by Keith Excellent tool.
I've had the unit about 2 months now and waited to review it until I had changed the blade as that appeared to be a challenge.
I've been using the unit to chip through a large pile (4x8x60) of tree branches from twigs to 3 inches as well as pine needles and leaves. The unit has started easily every time. The only jams caused by accidently leaving a branch blocking the blade a couple of times. This is noticed on startup as the belt (by design) slips and starts to smoke. A little scary the first time, but it saves the motor.
The leaf chute works for very loose stuff. It will clog up if you dump in a basket of leaves at one time. You must then use a stick to lift up the pile and let a few feed through. I didn't try using the collection bag. I found a garden cart is able to catch most of the mulch without a mess. The mulch produced is small and good for spreading in the garden or a compost pile.
The blade seemed to noticeably dull after about 10 hours of use so I started leaving the larger branches aside until I could get around to changing the blade. Changing the blade the first time was somewhat daunting as you really need to remove the entire chute and grate arrangement to get at the nuts holding the blade in. Once removing that stuff and overcoming the factory tightening it was easy to replace the blade. Putting it all back together took some ingenuity and patience, but wasn't too hard.
The unit is quite heavy, so moving it more than a few feet you need some kind of a tow vehicle.
January 22, 2013
Rated 5 out of 5Â by memoryerror A very nice chipper
This is a rock solid, easy to use chipper. It is easy to assemble (write down the serial number first), and started by pull cord the first try. I especially like how it may be used while still attached to the lawn tractor. My only complaint is that it does not work well with the bag. The chips back up into the machine and bog it down. This happens even before the bag is full.
July 9, 2013
Rated 4 out of 5Â by hergy5 chipper
Works better than I expected. Limbs up to 3 inch, no problem. Over 3 inch and they can be difficult to feed unless they are perfectly straight.
July 1, 2014