Rated 2.7 out of 5Â by 22
Rated 1 out of 5Â by Plouffe Poor Result
I was wondering if someone could tell me what I did wrong.
I rolled the product on my cobblestone patio and ended up with a white washed finish. I can not even see the color of my stones anymore. I perhaps applied too much of it, but ended up being very bubbly and white washed look.
July 17, 2014
Rated 1 out of 5Â by Gomez Never purchases again
I used this sealer followed the instructions put two heavy coats . With in 2 months it started to pill off I have flag stone drive way that i used it on. I would not recommend it . Yes it looks nice for a month or two but it pills right off after that.
July 6, 2014
Rated 1 out of 5Â by Tim97444 Milky finish on colored concrete
I tried 4 different times to make this turn out without a milky white finish over my tan colored concrete and everytime it was a failure. The folks at Behr who told me it would improve after it was fully cured, unfortunately there has been no change in a month.
It says wet look which would lead you to believe it would add a nice rich look however it did the exact opposite.
I bought a different sealer and it turned out perfect the first time. The Behr product is going back and I have my fingers crossed that the Stripper works better than this did.
See the pics, the poor result is beyond explanation.
The 3 milky spots are from the Behr Sealer - Darkest is from the other manufacturers product - Next to that is the bare colored concrete
On other areas with larger exposed aggregate it did leave a nice shine on the exposed rocks but the color in between is milky white.
July 23, 2012
Rated 3 out of 5Â by Wino after a year
on textured gazed tile it looked fine indoor and outdoor for a year. Indoor reapplying WETLOOK restored the shine, outdoor
I had to remove WETLOOK with a paint remover to remove the whitish scum and restore the tile a normal look.
August 11, 2014
Rated 5 out of 5Â by conic So happy with result!
I applied this product to my 19 year old brick paver deck that has never been sealed. Prepped with a good power wash, general purpose soap cleaner, and replaced the joint filler with a polymeric sand. I was worried about using this product because I know you usually get what you pay for and it cost a lot less than other premium sealers. I could not be happier with the result. My old sun beaten deck looks better than new. In fact, I am so happy that I decided to leave feedback (very rare for me unless I am upset with something). Cleanup and application was easy, I used an inexpensive garden sprayer and paint roller. Used 2 gallons on a very big area.
June 8, 2013