Rated 4.2 out of 5Â by 24
Rated 1 out of 5Â by Graham Realy Bad
I bought this router in a 3 base kit and returned it one week later. The power of the router is very low and struggles to make cuts in hard wood and because the motor housing is made of plastic as the motor warms up fine adjustment is almost impossible to make. Also the lack of a 1/2in collet restricts the amount of bits that can be used with this system. If you can afford to get a router with a metal body and base then do it, you may spend a little more money but it is well worth it in the long run and far less frustrating. In my opinion Porter cable and Dewalt make the best routers you can buy.
March 17, 2007
Rated 5 out of 5Â by CarpenterHalifax Carpenter N.S
Great little router! Use is for cutting out hinges in doors and small projects! Awesome !
January 17, 2012
Rated 4 out of 5Â by rryan905 Recommend for the DIY'er
This is a great little router for the DIY'er. I've used this router against 1" hardwood as well as 3/4" plywood with minimal RPM reduction under full load.
February 27, 2007
Rated 3 out of 5Â by Alan Feature quality has been lowered.
This router is ok, but not nearly as good as the last Ryobi I had, due to the adjusting mechanism. I don't care for this design at all but it's all they offer now. My other one was stolen but it had a band adjuster around the body and an adjustment measurement around the band with a huge lock. Just unlock it and turn the dial to add or subtract height. This one is not nearly as easy or accurate and it has a lot of looseness in it during the adjustment, making it less accurate, or harder and time consuming to adjust.
July 21, 2014
Rated 4 out of 5Â by PowerToolUser1 Great router for beginners and DIYer's
Got this router for father's day last year, and it is a good little router. If I were doing production work, I would get something with an alloy motor body and more HP but this router does a great job at what it is designed for. Last month I made some furniture for my 2 year old son and so I made a template to trim the parts to their final size using a template cutting bit and it was a snap. Then I used a round over bit on the edges. I even used a 3/4" bit to cut dadoes and this router took care of the job with no problems. Yeah the motor body got a little warm, but that was after 30 min. of routing. It can only use 1/4" shank bits, but if your bit is sharp it will produce clean cuts, so I wouldn't shy away because of this. Oh and there are plenty of bits out there for this router, I have 27:) I would say the only cons are it is a lightweight so I would not put it in a table to make door panels, and the depth adjustment knob sticks a little when dropping your bit down to trim edges.
October 9, 2013