Project Guide

How to Make a Jewelry Organizer

1
MEASURE
Step 1

Measure and mark cuts on the 1 x 4-inch x 8-foot common board according to the cut list.

2
MARK
cuts diagram

When finished, you will have two 20 ½-inch and two 15 ½-inch segments marked.

3
CUT
REPLACE THIS TEXT

Use a circular saw to make the cut along all the marks you just made. 


Tip: Use sanding block to smooth any rough edges.

4
PAINT OR STAIN
Step 3

Paint or stain all cut pieces prior to assembly.

5
BUILD THE FRAME
Step 4
  • Lay the two 20 ½-inch sections vertically on the table. 
  • Lay the two 15 ½-inch sections horizontally at the top and bottom of each of the 20 ½-inch sections to form a rectangle. 
  • Place a corner bracket in all four corners of the rectangular frame and secure to the frame with a drill using the hardware included with the kits. 

Tip: Use wood glue along the inside edges of the cuts and allow to dry for an even sturdier frame.

6
ASSEMBLE ALUMINUM BACKING
Step 5
  • Center the piece of aluminum metal in the middle of the frame opening. 
  • Secure to the frame using a heavy-duty stapler and staples.
7
ATTACH HARDWARE
Step 6
  • Center the saw-tooth hanger along the edge of the top of the frame with the teeth facing down toward frame opening. 
  • Use a hammer to secure to the frame with included nails. 
  • Flip the frame over and drill three evenly spaced holes on bottom section of the frame with a drill and a 1/8-inch drill bit. 
  • Push the screws that came with the decorative knobs from the back of the frame through the drilled holes. 
  • Screw the knobs on to the screws on the front of the frame.