Since it is an uncut slab door you can decide what is the top and what is the bottom depending on the grain direction you like best -- hope my answer helps
it's just a slab, it's hollow throughout, drill your holes where you want them, be careful , make sure you use masking tape when you drill or the veneer will splinter.
you have to drill it yourself. be sure to put masking tape over the place you are going to drill if you don't the wood will splinter
Please visit your local Home Depot store for special ordering availability on interior flush doors. Thank you so much for your inquiry today!
yes
JELD-WEN may be able to provide a custom order for a slab in the dimensions that you are looking for. Please contact your local Home Depot store for ordering and availability in your area. Thank you for your inquiry.
Jeld-Wen provides a sticker that indicates the top side of the door. JELD-WEN may be able to provide a custom order with a lock block on both sides of the door to suit your needs. Please contact your local Home Depot store for ordering and availability. Thank you for your question.
less than 1 inch on either side
The Unfinished Flush Hardwood Interior Door Slab weighs approximately 50.5 pounds. Thank you for your question.
Also, if you plan on putting doorknobs in, there probably won't be any fill where you want to place them. Good Luck