T50 1/2 in. Leg x 3/8 in. Crown Galvanized Steel Staples (1,250-Pack)

They are galvanized which holds up better in outside and wet conditions. However, in my opinion they are not very strong for your application.

Yes I believe they will. These are T50 Staples which fit in most staple guns and hammer tackers. They are 3/8" wide with the legs that shoot into the material being 1/2" long. I used them in a generic hammer tacker and they worked fine.

If the manual for the tool specifies that it works with 1/2-inch T50 staples, it should be fine to use these staples. Feel free to contact us at customercare@arrowfastener.com or 800-776-2228 if you have any more questions.

They should work. You might find that for that small of an area 3/8 will hold just as well and will go in easier. Remember the staples only hold the felt in place temporarily until you get the shingles laid.

Sorry, I don't know. Check with Craftsman for correct size staples.

I don't, but perhaps your local Home Depot does. Why don't you give them a call?

1250 staples in a pack, 24 packs of staples in one carton.

Yes

That's kind of a trick question. It depends on the thickness of the carpet and the type of wood you will be stapling into. You want the staples to sink into the wood as far as possible to help reduce pulling out later when they start to see the stress of traffic. However, keep in mind that if you have a harder would, you my find that longer staples will not go in that easily. Personally I would probably try these 1/2" length. If you have an average shag carpet and pine boards I think these will work just fine.

Hello, there. Arrow T50 staples should work with your tool. If you have any further questions about compatibility, feel free to give us a call at 800-776-2228 or email customercare@arrowfastener.com.