A: Jaws are smooth. Sure you can buy plastic serrated inserts if desired.
A: This was exactly what I was looking for, small, portable, and strong.
A: No, it is clamp on.
A: No, it has no holes for any kind of bolts or screws.
A: It has two apropiated holes to bolt on the side of a bench
A: It is clamp on.
A: You don't have to mount it with bolts because it has a built in clamp but if you want to, there are 2 holes on the side of the base of the vice for more secure set up.Hope I answered your question. set up.
A: will handle both.... just use a light touch on the tubing... 2 voices would work better...one on each end of the cutting area. p.s. I have 4 :)
A: It is holding my 3/4" pipe while I cut it with a Rigid pipe cutter. You do have to put it in the rounded pipe section below the top area for it to work well and it does have to be clamped pretty tightly if you are cutting and you may have to take a little less of a turn than you might with a heavier vice, but if just turning between 1/8-1/4 twist before rotating it's holding it well. I believe it is taking about 4-5 mins per cut, so about an extra minute per cut, but it's very convenient since it doesn't have to be mounted.
A: Yes it will
|Name||3 in. Clamp-On Vise||4 in. Drill Press Vise||Precision Vise FMZ with Clamp||4 in. Mechanics Vise|
|Jaw Capacity||2.375 in||4.25 in||2.25 in||4 in|
|Throat Depth||1.0 in||1.0 in||1.25 in||4 in|
|Hand Tool Type||Vise||Vise||Vise||Vise|
|Clamping Strength (lb.)||50||100||400||3000|
|View Product||View Product||View Product||View Product|