Redi-Twist Purifier 3-Stage Drinking Water Filtration System

So far the performance has been as advertised; clean, fresh tasting water. The installation and customer support, however, were lackluster at best and cost me more money at worst. In the instructions the "Tools and Materials" page clearly states that a 1/4" Tubing Connector was included in the box (See picture for proof). Instead, there was a packet that contained a plastic compression sleeve and insert connector. I have used compression fittings successfully before so I went ahead and installed it with the compression fitting. Frustratingly, I could not get the dang thing to stop a very slow leak. Per the instructions I contacted their customer service (Which has been contracted to a third-party) and they very helpfully sent an entire replacement faucet. It took nine days and when it arrived it was a good replacement for the faucet but an incorrect replacement for the water supply. The original was 1/4" and the replacement was 3/8". Further inspection revealed that the faucet model was not intended as a replacement for the system model that I gave to the customer support representative. I was tired of dealing with humans and waiting so I went back to The Home Depot, purchased a 3/8" to 1/4" coupler and the appropriate tubing (Which was only in 25-foot lengths!) and, thirteen bucks later, I was finally leak-free. While the system has performed adequately, be prepared for an installation hassle.

The Brita 3 stage filtration system is good substitute for the water pitcher they make , cleans impurities better across the board at a higher percentage . Plus with the addition of a third stage filter meeting NSF/ANSI standard Health Effects removing 94 to 99 percent of the following . Atrazine. 94.6% Lead ph 6.5 98.2% Lead Ph 8.5. 96.9% Lindane 99.0 % Cysts. 99.99 % NSF Protocal P231 Bacteria. 99.9% Virus. 99.9% NSF/ANSI 42 Aesthetic Effects Taste and Odor 97.4% Particulate Class 1 .05 to 1.0. 99.6% The filter kit is complete with one set of filters, mounting assembled faucet and water line. Filters are a twist in type easy to change. The filter housing is all plastic not the higest quality but should perform well for many years in a controlled environment. Not really for outside use in freezing temperatures. The faucet is mostly plastic and pretty cheap . I opted to install a higher end faucet from my old RO system. Two screws mount the assembly to your mounting surface. It's compact enough mounting under a cabinet is possible taking up less room then a RO system since no storage tank is needed. Single source water is needed tapping to your cold water line from your sink faucet is the easiest , but this fitting is not supplied. All together performance is a little better then my old RO systems water pressure at the faucet. Filter replacement is a little expensive about half the cost of the unit at 6 months or 1000 Gallons. But this isn't anymore expensive then other systems filter out there. Advantages over a RO system is no water waste. do your homework to see what you want to clean from your water supply and match your system to this . The Brita works for my application since I also have a hole house softener and filtration , but might not be suited for everyone's needs. This is a good system for DYI and the price point. Long term expense is in line with other system from high to low end.

Brita Redi-Twist Purifier 3-Stage Drinking Water Filtration System Great way to improve the taste and quality of your drinking water The Brita Redi-Twist 3 Stage Microbiological Under sink Water Filtration System has twice the water flow rate as compared to other comparable under sink systems. It reduces Chlorine CTO (Color, Taste, Odor), Atrazine, Lead, Lindane, Sediment, Particulates, and 99.99% of Bacteria, Viruses and Cysts. This not only improves the taste but the quality of your tap water. Which means your tea, ice, coffee, everything will taste better and will be better for you. The system filters approximately a 1,000 gallons, which could last up to 6 months. Filter replacement requires only a 1/4 turn twist to replace the filter. The system comes with a 3 year limited warranty. Installation is a snap, the only tools you will need are an adjustable wrench, a screw driver and a drill if you have to drill a hole in your sink to accommodate the auxiliary faucet. The filter housing comes with two locking water connections, so you only have to push the tubing into the fittings to make the connection. You disconnect your flexible cold water line under your sink, install the plastic tee supplied with the filter and reconnect your flexible water line. Here is where the install instructions breakdown, they fail to mention that there is a packet of three plastic parts, two of which must be used in order to complete the water hookup. I have included two pictures, showing the white plastic hex compression nut and the white plastic compression ring. Slip the compression nut over the line, then the compression ring. Push the plastic tubing all the way into the auxiliary faucet, slide the compression ring and nut up the line and tighten to the auxiliary faucet. (see pictures) Does not filter fluoride

Easy to install with push-in connectors. Great tasting water. The head that holds the vertical filters developed a crack in the second year but Brita sent me a replacement head under the 3-year warranty. Only reason for 4 stars was the box states the plastic tubing is 3/8 inch but actual tubing was 1/4 inch outside diameter. Recommend installing in-line shut-off valve to isolate Brita system.

Fitting and connections are weak. I ended up buying new brass compression fittings for all the connections. Filters and housing seem decent. The spigot that came with it is pretty lightweight - I don’t see it lasting long.

Purchased this unit because reviewers indicated you could notice an improvement in the taste of the water, which isn't always the case. Yes, taste is good - not quite as good as the local water store - but good, and it's now safe to drink. Installation was easy and no subsequent leaks. Limited space was a factor in this selection. Filters are spec-ed to last a very long time, though replacement is recommended annually.

going from old pipes to the filter system was a bit difficult since you really don't know what you need until you start. Once I finally got all of the parts and got it all assembled the product is good. Clear and clean water that comes out of the dispenser is easier to drink and feels great.

I am please with the results. Quick filter. installation is relatively easy. However, I already have the 1/4 connector installed from prior filter. It would be more challenging if I don't already have it.

Easy to install and great on the budget!

After purchasing this Brita filter, I was very disappointed. The water tastes awful I'm going to return it to try a reverse osmosis filter and definitely a different brand.