Kwik Seal Plus 5.5 oz. White Kitchen and Bath Premium Kitchen and Bath Siliconized Caulk

A:  They should not look the same. I have used the clear and the white and the clear is clear and the white is very bright white. I would double check the caulk tube to make sure you have the color you wanted and if the tube is labeled biscuit, which should be off white, or it is labeled clear and comes out white I would return to your local store as the item was labeled incorrectly. I would also return if you placed an order and did not receive the color you ordered. I hope this helps and good luck with your project!

A:  The clear will probably appear white/cloudy until it dries. The biscuit should at least appear to be a little tan in color when wet. If it doesn’t, it could be a labeling mistake.

A:  Clear caulking looks white in the tube, ones it's applied turned clear. Same with biscuit, seems white them change color.

A:  Thank you for posting your inquiry on DAP KWIK SEAL PLUS. As indicated on the product package label and supporting product literature: "KWIK SEAL PLUS (Clear) applies white and dries clear in 7-14 days (depending on joint depth, temperature and humidity).", DAP KWIK SEAL PLUS (White) will apply and dry white. DAP KWIK SEAL PLUS (Biscuit) applies as a light, off-white color. Should you have any additional questions or require further assistance, please free to contact DAP’s Technical Customer Service Department at 888-327-8477.

A:  I cleaned and prepped the surface thoroughly before use as well as allowed a full 24 hour cure on an indoor project. A day later the bead was dried up, cracking and separating. I specifically bought their top of the line product and am disappointed that I now have to redo the job.

A:  Thank you for posting your inquiry on DAP Kwik Seal Plus. As indicated on the product package label and supporting product literature, under label section FOR BEST RESULTS: "Allow caulk to dry at least 2 hours (longer in cool or humid conditions) before painting with latex or oil-based paints." Should you have any additional questions or require further assistance, please contact DAP’s Technical Customer Service Department at 888-327-8477.

A:  It says so on the package but I never painted mine.

A:  I believe it is, but you might want to check online to be sure.

A:  It says it is. You just have to let it set for 24 hours first. 

A:  Thank you for posting your inquiry. DAP Kwik Seal Plus is primarily designed for kitchen and bath applications, such as tile, tubs and shower enclosures. While it will bond to clean/dry wood, there are other more appropriate choices for this type of application surface material. At your convenience, please contact DAP’s Technical Customer Service Department at 888-327-8477, so that we can obtain some additional information from you about your intended project and to discuss more appropriate product options.

A:  Yes iI believe it can be applied to a wood surface. You will need to read and verify the instructions on the tube.

A:  Yes.  I used it to fill in holes, etc. when I had new baseboards put in.  I’ve used it to fill in holes in wall where nails had been.  It works better than the filler you have to sand. What’s the down side of trying it? 

A:  yes, I do not see why not. but if you apply enough the first coat - you shouldn't need a second coat

A:  Thank you for posting your inquiry. While one application is usually sufficient (and preferred) for normal joint/gap filling, for deeper joints, two or more layers (with a full 18+ hour drying interval between applications) can be done. Of note: Joint size should not exceed 3/8” wide x 3/8” deep. If joint depth exceeds 3/8", use backer rod material. Second applications can also be made to "touch up" missed areas, low areas or for better cosmetic appearance. Should you have any additional questions or require further assistance, please contact DAP’s Technical Customer Service Department at 888-327-8477.