|Name||1-Speed 1/2 HP Evaporative Cooler Motor||2-Speed 1/2 HP Evaporative Cooler Motor Kit||2-Speed 1/3 HP Evaporative Cooler Motor Kit||1 HP Evaporative Cooler Motor|
|Horsepower (hp)||.5 hp||.5 hp||.333 hp||1 hp|
|View Product||View Product||View Product||View Product|
There are multiple lengths, so you will need to refer to your user manual or spec sheet. All belts are 1/2” wide.
The motor switches speeds based on what you have controlling it - a wall switch or thermostat. The wall switch as a low cool or high cool mode - you choose, but it will not change until you manually change it to another mode. If hooked to a thermostat, the low and high modes are determined by temperature and the parameters you have set it to. If you have any additional questions, please call Dial at 800-350-3425.
You may have to check your user manual to verify the specs of the motor needed, but if it mounts to a 56Z frame and the cooler requires a 1/2HP 2-spd motor, then it should work.
comes with adjustable pulley
Motor Pulley size 3-1/2 x 1/2 recommended.
At least a 15 amp breaker with 14-16 gauge wires.
You will need to check with your user manual of spec sheet. It will tell you the length of v-belt needed.
I do not have specs for the FS450A motor, but our motors can be used in most evaporative coolers. As long as you match the horsepower and speeds, you should be ok.
Yes. The motor comes with the cord attached.
All Dial motors are clock-wise only and cannot be reversed.