#1 Home Improvement Retailer

Internet #100163329

Model #B37

Store SKU #446742

Store SO SKU #531677

1/2 in. (.700 O.D.) x 500 ft. Poly Drip Irrigation Tubing

$5798
/roll
Apply Now
Pay $32.98 $57.98 when you open a new card. info
Apply for a Home Depot Consumer Card
  • For use as main lateral when installing drip irrigation system
  • Top-quality material resists cracking, heat, UV and chemicals
  • Suitable for both above- and below-ground installation
  • View More Details
Store
0 in stock
Text to Me
How to Get It

Frequently Bought Together

Best Seller
+
+
Price:
$5798

Product Overview

Made with premium quality polyethylene resins, DIG's 0.700 OD drip irrigation poly tubing is designed to meet the demands of any drip irrigation project, above or below ground, from residential gardening to commercial landscape and agricultural installations. The drip tubing, commonly referred to as poly tubing, blank tubing or drip hose, is used as the primary supply line of a drip irrigation system into which micro tubing, drip emitters, drip line or micro sprinklers are connected to deliver water to the plant area. DIG's drip irrigation poly tubing coil has outstanding environmental stress-cracking resistance, high burst strength and UV protection for durability and long life.
  • Used as the primary supply line in a drip irrigation system into which micro tubing, drip emitters, drip line or micro sprinklers are connected
  • Designed to meet the demand of any drip irrigation projects from professional landscape to residential gardening installations, for above or below the ground
  • Resistant to cracking, heat, UV rays and chemicals
  • Produced using dow's 7510 linear low-density polyethylene resins with high environmental stress crack resistance and UV protection against the damaging effects of ultraviolet rays
  • Use with DIG's 0.700 compression fittings, color black, and Nut Lock fittings
  • Dimensions: 500 ft. with .600 ID x .700 OD
  • Bending radius: 1 ft.
  • Maximum operating pressure: 60 psi
  • Can be installed above or below ground
  • DIG's drip irrigation products may be exempt from residential and commercial watering restrictions (check local codes)
  • Maximum recommended flow rate per each length of drip tubing is not to exceed 220 GPH (3.6 GPM)

Compare Similar Drip Irrigation Tubing

Earthline Brown PC 100 ft. 1-GPH Pressure Compensating Drip Line with 12 in. Spacing (.700)
current product
Best Seller1/2 in. (.700 O.D.) x 500 ft. Poly Drip Irrigation Tubing
Top Rated1/2 in. x 500 ft. Drip Irrigation Tubing CoilTop Rated1/2 in. (0.710 O.D.) x 500 ft. Poly Drip Irrigation Tubing
BrandDIGDIGRain BirdDIG
NameEarthline Brown PC 100 ft. 1-GPH Pressure Compensating Drip Line with 12 in. Spacing (.700)1/2 in. (.700 O.D.) x 500 ft. Poly Drip Irrigation Tubing1/2 in. x 500 ft. Drip Irrigation Tubing Coil1/2 in. (0.710 O.D.) x 500 ft. Poly Drip Irrigation Tubing
Price
$3997
$5798
/roll
$5798
$5798
Ratings
(100)
(782)
(545)
(110)
Tubing Length (ft.)100500500500
Drip Line/Tubing TypeDrip or Emitter Line TubingDrip or Emitter Line TubingDrip or Emitter Line TubingDrip or Emitter Line Tubing
Irrigation System ComponentTubingTubingTubingTubing
View ProductView ProductView ProductView Product

Specifications

Dimensions

Assembled Depth (in.)22 inAssembled Height (in.)12 in
Assembled Width (in.)22 inInner Diameter (in.).50
Outer Diameter (in.).50Tubing Length (ft.)500

Details

Color FamilyBlacksDrip Line/Tubing TypeDrip or Emitter Line Tubing
Irrigation System ComponentTubingPack Size1
Pressure Rating60 psiReturnable90-Day

Warranty / Certifications

Manufacturer Warranty3 Year Warranty

Questions & Answers

Typical questions asked about products:

  • Is the product durable?
  • Is the product easy to use?
  • What are the dimensions of the product?

Customer Reviews

  • 4.4
    out of 782 reviews
  • 84%recommend this product
Filter by:
Showing 1-10 of 782 reviews
Blisters
Two months after installation to water a garden the tubing blistered all over the place and began to leak. Some blisters are convex and stick out of the tubing and some are concave and sink into the tubing.
by
    7 found this review helpful
    Fit perfectly with fittings without any adhesive...
    Fit perfectly with fittings without any adhesive
    by
    • Verified Purchase
    4 found this review helpful
    Tubing ID is too large for standard barbed fittings.
    This tubing is slightly larger than most 1/2 inch tubing. This results in standard barbed fittings leaking, In some cases the water pressure of 30 psi causes the tubing to blow off the fitting resulting a water leak that makes the entire system inoperable. I have no idea of why they make this tubing with a larger ID than most other brankds.
    by
      11 found this review helpful
      Not for novice
      This is my first attempt at setting up a system and found it to be difficult to unroll and lay where I need it without constantly crimping. When I turned on the water, it did not flow through the tubing due to multiple kinks. Would not recommend.
      by
        • Recommended
        9 found this review helpful
        easy
        Easy to use and cut. Strong enough to move and bend but doesnt kink or deform.
        by
        • Recommended
        5 found this review helpful
        This kinks VERY easy. I have purchased online (not Home Depot) wth exact same OD/ID that didn’t d...
        This kinks VERY easy. I have purchased online (not Home Depot) wth exact same OD/ID that didn’t do this. Hope it holds up:-(
        by
        • DIY
        • Verified Purchase
        6 found this review helpful
        My recommendation is based on a previous purchase and the fact that bought this product again. I ...
        My recommendation is based on a previous purchase and the fact that bought this product again. I have opted to install drip watering for all of my garden, bushes, and all landscaping except for the grass area. Direct watering saves a significant amount water and money since we live in a "High Desert" climate and water source is the city water system. This tubing allows you to target certain areas and also provides the ability to modify your landscape as you add new plants. It takes a little bit of time to lay the tubing since the coil is tightly wound and tend to kink as you lay it out. However, be prepared to use landscaping staples you fasten it to the ground as you lay it. Buy a package of figure-8 tube ends to make an end of line termination. You can extend your line in the future by adding a coupling. The tubing is connected by pressing it over a plastic-barbed fitting. I recommend having a heat gun or hair dryer to heat the end of the tube and it will slide onto the connections with very little effort and it hold tight as the tube cools (a few seconds).
        by
        • Verified Purchase
        • Recommended
        15 found this review helpful
        Just the right size to fit over 1/2 inch rebar to protect fabric on a DYI greenhouse. worked for ...
        Just the right size to fit over 1/2 inch rebar to protect fabric on a DYI greenhouse. worked for my application.
        by
        • Verified Purchase
        • Recommended
        11 found this review helpful
        This is a product I expect to need to replace...
        This is a product I expect to need to replace every year or so. Nothing special, but seems to work.
        by
        • Verified Purchase
        6 found this review helpful
        The 1/2" mainline tubing was indistinguishable from the tubing I have purchased in the past from ...
        The 1/2" mainline tubing was indistinguishable from the tubing I have purchased in the past from company that specializes in irrigation products. The problem with this company was the shipping was very expensive. From Home Depot it was free! I use this in my apple orchard with 2 gallon per hours pressure compensating emitters spaced 36" apart. With trellis hangers it attaches easily to 12.5 gauge high tensile wire and makes a very clean installation and the emitters are off the ground. The only issue is the same as I had with other mainline tubing I have used is the actual unwinding. When dealing with a 500' roll in row that is 200-300' long unrolling is an issue. If it pulls through the center IT WILL KINK. I made a spinning jenny similar to what is using for unrolling high tensile wire. It would be nice to just be able to purchase that too.
        by
        • Verified Purchase
        • Recommended
        12 found this review helpful
        Showing 1-10 of 782 reviews