Classic 400 32 in. x 60 in. x 60 in. 3-Piece Direct-to-Stud Alcove Surround High Gloss in White

You’ll just need to fir walls out to plumb and level the floor. I’ve had to make level lines and just rip every plate piece and in between custom to make a level platform for the tub to sit on. You can use a table saw or power planer for this. Making a level platform is a good fix for out of level floors. Sometimes a step is necessary depending on height of platform ? As someone stated already they had a hard enough time going together in a perfect situation. I suggest getting the rough opening as close to perfect as possible as these units all differ a bit. But most importantly they rely on things being plumb and level in order for the lap joints to properly fit together. DO NOT CUT , VERY BAD IDEA. look at making the rough opening plumb and level as chance to fancy up an otherwise boring design ;-)

I purchased sidewalls separately and with some adjustments to studs was able to use normal size 3 sided surround with some variance in front where sidewalls would normally come

But what if my bathroom has a window in the middle, is it easy to cut off.. thanks for your time..

It doesn’t matter, as long as the measurements of the alcove with drywall allow it to fit.

This specific one is just for a tub but Home Depot does carry the shower version. It’s a great and has lots of space.

They shouldn't. The tub is a left or right hand purchase; the walls are drilled on site to accommodate your fixtures. Looks like you got a returned panel included in your wall purchase. Email the company and see what they say. They typically won't sell you an individual panel if you break one or mess up the fixture openings, rather they make you buy a whole new set. Sending out a pre-drilled panel should be different, but you never know. If all else fails, check with your local plumbing supply. They might have some sort of decorative cover for just such cases.

If the stud is keeping the panel from fitting the bathtub correctly, then the stud will need to be cut down where the bump is. For example, if the bump is only hitting the stud by 1 inch, then cut and inch out of the stud where the bump is hitting the stud. If the wall is a load bearing wall, then an additional stud or two should be installed on each side of the bump to ensure that the load is not compromised. Since the panels are secured at the top where the flange is located, not all studs need to be 16" on center.

No, this product is not guaranteed to work with , or designed to work with a regular iron tub.

Yes

Hi, Rod! Thank you for your question. The Delta Classic 400 32 in. x 60 in. x 60 in. 3-Piece Direct-to-Stud Alcove Surround High Gloss in White can fitted for faucets and tub spouts on either the right or left side. Best Regards, Rosanna