Designed to connect the water line from the pump to the pressure tank, this 13 in. long 1-1/4 in. dia. Brass Tank Tee can be used with 1/4 in. and 3/4 in. ports. Solid brass design meets federal low lead regulations.
1 in. female or 1-1/4 in. male tapped
For vertical pressure tanks only; fits water worker tanks 44 Gal. and larger and fits flotec tanks 50 Gal. and larger
Two 3/4 in. ports on the front pressure relief valve and boiler drain valve
Two 1/4 in. ports on the top for pressure switch, pressure gauge or plug
Solid-brass design meets federal low lead regulations
Product Depth (in.)
Product Height (in.)
Product Width (in.)
Compatible with all models
Male Pipe Thread
Fitting or Connector Type
Product Weight (lb.)
Warranty / Certifications
Questions & Answers
Typical questions asked about products:
Is the product durable?
Is the product easy to use?
What are the dimensions of the product?
out of 39 reviews
100% recommend this product
Showing 1-10 of 39 reviews
Nov 16, 2021
Nicely made. Threading is smooth and exact. Used blue...
Nicely made. Threading is smooth and exact. Used blue Teflon tape and no leaks at any of the seven joints.
Nov 11, 2021
No cracks in the casting and machining seems to be...
No cracks in the casting and machining seems to be high quality. Threads are in great condition and there were no leaks. Sticker is a pain to remove..
Nov 9, 2021
Nov 9, 2021
Easy to install and looks like a professional install...
Easy to install and looks like a professional install
Oct 26, 2021
Not in store
It’s made by Home Depot Everbilt brand. Enough said. But would still be nice if they stocked it in store so I could use with tank they stocked. Only half the job Home Depot. Now I’m on road heading to other stores.
Oct 15, 2021
Apr 1, 2021
Rating provided by a verified purchaser...
Rating provided by a verified purchaser
Mar 7, 2021
There is still a leak where the tee screws into...
There is still a leak where the tee screws into the bottom of the storage tank. I removed it put more tape on the thread and tightened in in much tighter. It slowed down but still has a small leak at this same connection. I looked very carefully to check if the leaks could be coming elsewhere. It is definitely coming from the tee connection to the tank. Of course the pump, tank and plumbing must be removed again and tightened even more. I am going to wind plumbers string also to the tape and hope this will do the trick, I tried another fitting to see if the thread was better. It was a tighter fit so I am sure the problem is in the male end of your tee the thread was cut to deep. It would wonderful if you could supply another fitting. I am sure it would correct the leaking problem.
Response from Everbilt TeamMar 7, 2021
Lyle, please contact us at (844) 251-7446 to discuss your issue.
1 person found this helpful
Jan 14, 2021
Th product was reasonably price and easy to installed...
Th product was reasonably price and easy to installed
Connect a submersible well pump dischargeConnect a submersible well pump discharge pipe to the horizontal pipe entering your house with this 1-1/4 in. pitless adapter. It includes two pieces that slide together to form a water-tight seal, you can remove the pump from the well for service without digging the horizontal run of pipe. This pitless adapter has a brass body with Buna-N O-rings and gaskets and meets federal low lead regulations.See Full Product Description