|Name||2-1/2 in. Black Barrel Bolt||Black Gate Latch||Black Slide Bolt||5 in. Black Heavy Duty Gate Slide Bolt Latch|
|Features||No Additional Features|
|View Product||View Product||View Product||View Product|
In total 4 inches. An inch and a half for the section with the screws and an inch and a quarter for the section with the head to latch. The middle section is on an angle and is an inch and a half
This Gate Latch is lockable by padlock.
As long as there is a stud to secure it
I attached a rod to the latch that extends to other side of gate. The rod was fitted through the opening of a screw with closed circle head. The screw was mounted on wall of garage.
You have to reach over gate and pull to lever to release.
Can’t you put a handle on the wire on the inside to make it look not so cheap looking, or a latch of some kind to have it look better from the inside? Thanks
There are 50% of hardware which are rusty.
If the steel gate has steel sheeting then these screws probably would not work. They will work on wood or soft metal that self tapping screws can form a thread in as you screw them in but I think most steel is too hard for self tapping screws to work on.