Contemporary Palomino Leather Recliner and Ottoman with Swiveling Mahogany Wood Base

Thank you for your question. Yes there is some assembly required. Thank You AB

I was told no, they couldn’t do that. Remember this was one person that may have not known. Disappointed.

Easy !! No instructions but intuitive. Left arm labeled " left " , etc. Had to guess which screws went where but was again easy to figure out. I assembled with the tools supplied and would've gone faster if I got up and got my own tools .

Thank you for your question. The seat height is 17.5 inches. Regards, KH

I am thinking about 4-5 Inches in depth. Very comfy to sit and relax in.

This chair is great. Kind of easy to assemble. Very comfortable. But does not totally recline flat. Reclines about 60 degrees, which is fine. Price is great for the quality. Love it.

It has foam cushions.

Mine does not have lumbar support. I am petite and always seem to add pillows to my chairs. Have you considered a professional lumbar pillow as sold a chiropractic offices? These real lumbar pillows can be used in the car and also the home office. I have two of them. Good luck.

Thank you for your question. Please contact customer service in regards to any discounts. Regards, KH

Yes, some assembly is required but everything you need comes in the box. A picture diagram (very basic), hardware and tools are included in the box. Each item in the box has a number that is used on the assembly diagram, so you can determine what hardware goes with each part. The main components have been assembled but because it needs to be shipped (in a large box), final assembly is required. The foot stool is in four (4) pieces. Attached two legs to the base, then attach the cushion to the top of the legs. Because I was worked alone, I used an existing piece of furniture I had to prop up parts while working (instead of an extra pair of hands). The chair also has 4 big parts. The hardest part for me was getting it out of the box because it is a little bulky. I put the box on the side and it fell out. The chair base and cushion you sit on it already assembled. The chair assembly requires the back of the chair to the bottom cushion and base (that are already assembled). There are two steps to this. Once the basic chair is assembled the final step is adding the two arm rests. Before assembly I studied the diagram and laid out the hardware, then I practiced putting some of the hardware in the destination holes to make sure the holes are properly drilled. Everything worked out fine but it make take a little wiggling of parts to get it all aligned. I did this myself and am not a very mechanical person. Good luck!